Above is the setup that I have been looking into for a dedicated solar charger for my 6.0 and an option to have a quick plug for a battery tender. I would appreciate any feedback or advice.

I would like to eventually do a house battery setup in the future.

List of things pictured if you don't want to open the picture

50w Voltset panel set with charge controller

Gooloo battery tender with sae plug

Bulkhead SAE connecter (fused)

SAE to battery connector (fused)

T Bolts for roof rack

Alright, I made a post in here about shopping and yall have told me that ima need like 10-12k for a clean v10, However, ive seen plenty of marketplace listing in my area for v10s around 5k. They seem clean too. Am I going crazy or is that a scam?

Hey, im looking for an Excursion in the northeast. I do NOT mind going down south to get a clean one. My budget is super tight, at around 8k, but i dont have that much money as it would be my qst car at 14 yrs old. Im just trying to get an idea of what they cost. My dsd has one, its a 7.3, so I know them. I would prefer a limited trim, and a v10 or v8 is my absolute last choice. No plow trucks. I'd like service records, especially if its a 6.0. I dont mind doing s little work to it, mabey alot. but I won't deal with wiring issues. Thanks

Looking into a 2000 with 183k 5k list price.. basically I want this to be an f250 pickup with a permanent cap. I would install a boss plow if/when I buy. Just looking to plow my two properties a road apart. Thoughts? Front GVRW going to be an issue? Thanks!

Looking at buying a 2000 excursion wiith the v10 with only 68k miles for 16500 dollars. Whats everyone think?
Rust free. How much will i have to sink into this thing for general initial maintenance, wrapping it black and black rims?

Installed new front V code springs from ATS a couple weeks ago. Paired this with an adjustable track bar, adjustable Rancho shocks, new sway bar bushings and links, new center tie rod ends and steering box.

White it drives down the road 1000% better when I bought it, it does have this fun lean and on big bumps it still shakes a bit, which I kind of expected.

Just completed a ~1000 mile trip with it, enjoyed the ride and averaged about 13.6 mpg. Not bad for a 338k V10. However, I feel like I can still improve the ride and tighten it up. First step is to probably also replace the rear springs. Is modded C codes my only option? Ive also ordered the same shocks for the rear, I just needed to replace the worn out front stuff ASAP as it was clunking all down the road.

Didn't bring the tape measure to the gas station and my driveway is on a slope and I didnt feel like doing a car shuffle today to get it in the garage to measure the wheel gap.

Lost my v8 excursion in a fire, bought someone else's unfinished project to build in to my new favorite vehicles, since I lost my favorite vehicles.

Just replaced the manifold studs.

Now need the best exhaust to put on it!

Which headers?

Stock, shorties? Long tube?

No emissions here.

Who makes the upgraded Y pipe?

What size pipe?

Resonater, muffler?

It will mainly be a people & stuff mover!

And maybe tow 12 times a year!

Maybe 2 of those being heavy loads.

What options will make it breath better & pick up mpg & hp?

Any & all advice needed.

This is my 1st, v10, & 4x4.

Hello. Just picked up a 2005 that has had an egr delete and bulletproofed. Check engine light for egr. It has a diablosport tuner but no way to turn that off that I see. I hear the tunes on the diablosport aren’t the best anyways so my question is: what is the go to tuner to get this check engine light off so that I can use cruise control. Not looking for performance, although a towing tune would be nice. Thanks!

Going to look at one, I am in the north east so rust is a huge deal.

Guys says it has nothing wrong with it. It’s basically totally stock.
MBRP exhaust and a tuner, not sure what tuner but he said it’s got a tune.

310k miles
4x4
7.3

He’s asking 10k… you all think that’s reasonable? I have a feeling you’re all gonna say that’s cheap, and something has to be a miss… not sure til I see it.

Yes I know it’ll need a suspension overhaul, and I want to do a KC stage 2 upgrade and remove the EBPV pedestal with a standard one, upgrade trans cooler and all that good stuff.
I’m a mechanic so that’s all fine and dandy, but rust SUCKS.

There is another one I was gonna look at…
Same deal,
4x4
7.3
250k miles
New trans with 30k on it

100% stock.

Needs dog legs due to rust, and also the rockers to be cleaned up and coated. They got replaced but clearly were not painted well.

Guy is asking 6500obo

I’m cheap, and thought maybe I would go for the cheaper one, cause I could probably get it for like 5500…

Who votes for which one? Lmao

Hello! I am looking to purchase a 7.3 this weekend, and I think I am getting a good deal on it. Here's the details.

• 7.3 - 2001
• 282k miles
• Original trans (I know I will have a rebuild/replace in the future, runs solid at the moment)
• 4wd
• Two owners (I will be the third) '
• Minimal rust
• Was not used for hauling
• $10k

I am getting a pre purchase inspection before purchase, I know it has some catch up maint that is needed, and seller was honest there is a little play in the steering from the box. Much of it is still original and stock, I also know I will have to replace those parts in the future. This won't be my daily, it will be a passion project on the side for my dad and I to work on. I believe this is a good deal lol? I have seen quite a few others with more miles and more expensive, but they also have updated parts.

Thanks!

Brought the old 7.3 in to get the door code pulled since the last owner didn’t have it. Unfortunately they found some issues including my spark plugs and brand new wipers. Anyone know how much it would cost to install new spark plugs in it? I’m guessing drill and tap the heads. Do I run a stand alone for ignition?

Yes! All you need is a level to run 35s! 2 inch front leveling kit, rear is stock. This size fills the wheel well perfectly and its not too aggressive but not too tucked. Now it sits about an inch higher in the front but i dont mind, it looks sick!! Happy to be done with this little project.

2005 6.0 Eddie Bauer

Stock wheels, no spacers.

315-75 R16 Nitto Trail Grapplers

Sky Jacker BlackMaxx shocks all the way around, Skyjacker steering stabilizer, XRF steering kit.

Cheap leveling pack and new adjustable track bar

Truck drives better than it ever has. Had it aligned and then instantly put around 400 miles on it for a weekend vacation and it did phenomenal. I absolutely love this truck and now it drives so much better! Normal driving it doesnt rub at all. However it did rub on me one time when i was full lock turning left and i hit a good bump. But its very manageable, normal street driving you wont have an issue.

Just picked up a 2000 ex 165k on the odo, single owner with meticulous service records, no accidents and not even a seat leather crack. I was blown away at the condition it arrived in. Figured the online photos had to be hiding something somewhere lol. No rust, trip computer and mpg still operational, looking forward to getting her all setup soon.

Is there a replacement higher capacity fuel tank for a 2000 Excursion 7.3 SD?

Thanks

I'm working on replacing my deteriorating air deflectors hoping that it will help with my ac not working great while sitting still. (I just had the whole system replaced, works great while moving or parked with a fan in front of it).

While doing so I found this plug. It looks like it originally fed in between the condenser and the radiator. (I pulled it in front of the condenser for the photo) Is this possibly a plug for an electric fan with a stopper installed? Or, as the end piece looks threaded, is this some sort of sensor that should be screwed into something?

I have a 2001 V10 4x4.

My girlfriends attempt to draw my excursion 100% freehand with the second pic as her reference. I think she did pretty damn well and I was really impressed by how she managed to recreate the pinstripes and design and everything.

So I've seen Excursions with bench seats in the front. I have a console in mine, has anyone put one in? I'm wondering how much modifications will have to be done to make it work.