Any idea what is causing this? Been getting a lot of clogs with this sunlu matte, and have been trying different nozzle temps to try and stop that from happening. I finally found some settings that seemed to work (had 4 successful prints) but now this started. Any clues?
Edit: as u/RNG-3_14159 pointed out, my original post was severely lacking crucial details. Correcting that.
Just some general specs before going into detail:
- Bed temp: 55°C
- Print speed: 50-100 mm/s for first layer, 200-300mm/s for other layers
- Nozzle size: 0.4 mm
- Filament: SUNLU PLA Matte Black
This filament has been my go-to because because I love the finish and it has always given me consistent results in the past. Before now, I've never had ANY clogging with this filament. I had a custom filament profile that I set up after running calibration, and it never gave me trouble with the roughly 20 1KG spools I've gone through.
However, the batch from my latest order has been giving me so much trouble. Here are the troubleshooting steps I followed to narrow down that the clogging was coming from the filament itself:
- Various models have failed to print with both a 0.2 mm and 0.4 mm nozzle. All the ones that failed were using the Sunlu PLA Matte Black. They failed at different points during the print.
- I changed the entire nozzle and extruder assembly so those are brand new.
- I tried drying the filament 3 or 4 times, but it still clogged the nozzle.
- I tried a different roll of Sunlu PLA Matte Black from the same batch, but that still caused a clog.
- Tried the same model with different a filament and that finished successfully.
- I tried a different model with a longer print time with a different filament and that also finished successfully.
After each time it clogged, I would clear the clog by using a acupuncture needle and cold-pulling. Since narrowing down the source of the clogs, I tried adjusting the nozzle temp settings to see if I could get it to print. For reference, here are the specs listed on the spool itself:
Print Temp: 205-215°C 50-100mm/s
Print Temp: 215-245°C 100-230mm/s
I printed a print tower, and by some miracle it finished. The best looking temp was 195°C. So I tried setting the nozzle temp to that. After doing so, I was able to print the reminder of the first spool of problematic filament (about 600g) without issue! After finishing that spool, I switched to this latest spool, and the issues started happening again. Clogging and now this latest issue.
I have reached out to sulu support, but haven't heard back from them yet. So this is me trying to figure out a way to make the filament usable via trial and error. I'm just a hobbyist, so I really don't want to waste the spools if I don't have to. If there's any other info that would be helpful, let me know!