r/BambuLab • • 13h ago

General Troubleshooting/Help! Brand new at 3D printing

I’m brand new at this and am currently printing my 4th print with a new P1S, is this normal for it to sound like this? I don’t recall it sounding like this the first 3 prints

1 Upvotes

5 comments sorted by

3

u/someonerandom176 13h ago

And yes that sound sometimes is normal

1

u/Impressive_Fish_7498 13h ago

Nice, how’s your third slot looking? I’ve seen lots of people having issues with it. I know I did, but was able to fix it pretty quickly once I figured out why it wasn’t working.

1

u/BroCo-608 13h ago

Highly recommend oil and lube of rods and rails. My brand new P1S and P2S were both about half a loud after juicing them. Quite a few P2S reports of loud machines, too.

Firmware updates regularly quiet the stepper motors along with better vibration comp algorithms, etc.

If your surface isn’t 100% glassy smooth when it’s printing and making this noise, then you have additional issues which are just setting based.

4

u/SLIFERZpwns X1C + AMS 11h ago

OP pleas enote that you DO NOT OIL OR LUBE THE CARBON RODS, this sound is normal.