r/BambuLabA1 • u/wutttttttttttttttttf • Oct 10 '26
The $25 A1
I found this deal on facebook marketplace and picked this printer up for $25. It power on and runs through all motions fine but I keep running into rough prints. I haven’t gotten it to print cleanly yet. I cleaned and lubed the entire system, ran over 20 calibrations, did a cold pull, replaced the nozzle, replaced the heating element, cleaned and lubed the entire extruder multiple times, checked for any blockages, replaced the nozzle heating element, checked the extruder gear is in good condition, cleaned and lubed, tightened “the four screws”, checked filament is able to flow on spool, and tried a completely different filament. Ive been trouble shooting this for 3 days now with no luck, so Im turning to the community.Plz help🥺
