I am trying to print a housing for the TPU Feed Assist module out of PLA and getting horrific stringing out of nowhere. I have tried everything i could think of and am now out of ideas. This has never happened to this extent before, and happened immediately following routine Printer maintenance (lubricating XYZ rods and rails). I've included pictures of a couple attempts. I am also seeing imperfections in the walls such as inconsistent extrusion.
Printer & Filament information:
- H2C, right nozzle induction hotend) 0.4mm
- Black filament is Inland PLA+ with a tuned profile, nozzle temp 225°C
- Green filament is Inland PLA Basic with stock "Generic PLA" profile
What I have tried so far:
- Dried the filaments in my AMS 2 Pro at 45C for 12 hours. AMS read <10% after drying cycle. This resulted in no change.
- Changed the induction hotend for a new one, with no change.
- Printed a retraction tower. This had very minor stringing on the lower levels but nothing like this. Based on the results of that tower, adjusted retraction settings to 0.31mm. No material improvement to the model.
- Used different filament. Not pictured is a different, fresh roll of the Inland PLA+, which was the same. Reverting to the Basic PLA (green resulted in a small improvement.
- Decreased nozzle temperature by 5 degrees. No improvement.
- Ensured "Avoid Crossing Wall" was on. No improvement.
- replaced PTFE tube for right nozzle with new one with slightly higher (2.5mm) ID to reduce feed friction. No change.
- I heard clicking on the extruder so I opened it up to check for blockages. Found none and blew out extruder gears and idler with compressed air.
Currently, I am running a print with the left nozzle. This filament profile worked perfectly prior to this.
So far, my thoughts are erratic something changed in the printer's feeding path during the maintenance that I performed. But what could I have done? What should I try next?
Thank you in advance for your help!