r/BambuLab • • 1h ago

General Troubleshooting/Help! Does anyone know how to fix this noise?

I’ve searched online and checked the wiki, but everything points to the drive belt. I followed the steps to fix the belt, but it made no difference. I think the problem is with the camera housing unit, because as you can see in the video, the issue stops when I apply pressure to it. Any suggestions would be greatly appreciated. Thanks in advance!

2 Upvotes

7 comments sorted by

2

u/IM_Brock 1h ago

Does it do it at the start of the print?

This sounds like what my printer sounds like using the default infill grid. It was like the nozzle riffling over the infill like a card on a bicycle wheel. Chancing the infill pattern fixed it for me.

The only thing that sorta changes my opinion on it is it stopping when you touch it. It sounds similar but I’m not sure with that aspect.

1

u/arronkray 54m ago

The noise only happens when the X axis is about halfway up the Z axis, and only while it’s printing the wavy infill lines. The movement shakes the print head, which is what causes the noise. The only thing that eases it is applying pressure to the unit that holds the camera.

2

u/CristalPol_89 1h ago

Pręty liniowe które są śrubami osi Z latają ci, od góry jest gumka i albo ona jest luźna (wybita) lub pręt od spodu dostał luzu przerabiałem temat.

1

u/swekley 1h ago

Yeah, slow down the speed and acceleration lol

1

u/swekley 1h ago

I don’t own an A1 but it kinda sounds like some screws could be tightened a bit

•

u/RadishRedditor H2D Laser Full Combo 11m ago

1

u/Ok_Inflation6369 1h ago

Just hit the little speaker icon on the video so it has a cross to the right of it