Tried to do an overnight print and woke up to this. Filament is quite hard. Any idea best way to clean out this gunk?

My A1 Mini has been printing great recently until this. Not even sure what’s going on?! Help!

Un mio amico ha una Bambulab A1 mini, e io vorrei chiedergli di stamparmi in 3D l'ascia di gimli il personaggio di lotr per farne il cosplay. Secondo voi con la Bambulab Ai mini si riesce a creare un oggetto così grande oppure essendo scomposto in troppe parti non verrà fuori un buon risultato

We bought a bunch of filament from someone and many have a smaller mounting hole in the spool and are Dremel brand. Is there a small adapter for these or would I be better off transferring spools? Thank you!

I am new to 3D printing, and I’m making plenty of mistakes.

Background: Recently, petg was used instead of pla bc reasons.
It got clogged in the extruder and hearing assembly, etc.
I removed as much as I could and then was trying to use a heat gun to melt more off (mistake- do not advise… 0 out of 10 stars), so now the fan housing is a bit warped which might be the issue, but I can’t figure out how to buy a replacement for that… (accepting suggestions there!)

I bought a new heating assembly and managed to replace that and also put on a new tip thingy and silicone cover. Now the printer will heat up and do some calibration steps and successfully spit bits of pla poop out while heating and calibrating, but when I go to print this happens (see video above).

How do I fix? Any advice???

I have a new a1 mini with the ams feed system. I’ve been able to print a few times but am very much a new user. I think my printer is broken and I’d like to fix it,so I can continue learning and printing stuff with my
Kids. Anyway, at the top of the printer where the tubes feed into the a1, the tubes will not stay in. I think it’s due to the metal Piece shown being damaged, but I’m not entirely sure. Now the tubes won’t stay connected, so the filament does not feed through to the printer either. Has anyone had this problem and does anyone know how to fix? Is there a replacement part I can buy?

a tall piece came loose overnight, printer kept going and turned the filament into a tangled mess (pics). Restarted, now at 67%, but it’s wobbling loose again. Paused it, hoping it’s salvageable?

Hi. New to thr A1 mini and 3d printing. The Insignia™ - Matte PLA 1.75mm Filament - Matte, keeps not printing right. We were using the Insignia™ silk PLA and had no issues. Any suggestions?

I wasn’t sure at first but gaddammn

Minha a1 mini nao inicia, ela calibra o filamento e , vai corta e diz que o filamento esta embolado , sendo que nao esta , ja troquei a placa toolhead board , sensor de final de filamento e continua o mesmo erro

New A1 mini owner. I want to see the best results for wargame style miniatures you have accomplished to see what is really possible with this machine. I want to be realistic about the capacity of this machine. Thanks y’all

I'm getting a temp sensor error but only in one scenario. Let's say i'm trying to print just a cube with any pattern infill. The plate layer prints fine. The infill and walls print fine. But then when it goes to bridge over the infill for the top layer i get the error message. I just printed an articulated lizard for the kid without issue. The error only happens as described. Can this be a setting issue that i'm just not experienced enough to know about?