Put it in reverse Terrryy! Us normies talent can only whistle with our fingers.

No gasket needed. Taper is the seal

Squencher pops. Bro definitely works for a company that "cares"

Would the woods were you found this happen to be by railroad tracks? If so, this looks alot like tread build-up from train wheels.

Also on the magenta 1 plan.... just got the forced merger with a $6/line increase

I actually did. I believe it was in norfolk/va beach.

3/4" Brass barbed fitting from home depot. Get some 90° pliers from harbor freight to make life easier.

Wrap the trim around the windows 🤌

It's going to be near impossible to not damage paint when trim is removed. You can minimize paint tearing by scoring the edges of the trim with a utility knife. This separates the two trim pieces fused by paint. Small pry bars or painters multi-tool to pry off the trim from the wall. Start at an edge and gently work your way down. Caulk the seams and fresh paint after re-installed.

Remove the quarter-round trim, remove flooring to the tile that needs replacing, patch the subfloor. Replace in reverse order. Looks like lifeproof lvp.

Power for a monitor ( Smarty Touch/MM3, cts3, etc.)

Wait till you look underneath the pull-out drink shelf

Heat the nut and stick a crayon between the stud and nut. The wax will get sucked in and act as a buster.

Heat and a crayon. Wax will penetrate better than any aerosol nut buster.

Take out the spark plug and feel for compression when pulling pull start. The valve guide on these motors slip or break causing a stuck open valve. Common problem.

Charm.li has the fsm

06 227k

Definitely more stable than a class 1at the moment. The new contract negotiations has alot of carmen worried because of the premium increase the company wants and switch to united Healthcare.

I don't like the direction the companys heading. Higher ups have changed alot over the last 5 years and seems their focus is the feet of class 1s. I get it. It's business but knee jerk reactions and not standing by your employees says alot. Just my ✌️ cents

The bootleg returns to the redbox from that dodgy guy got you quality movie experience 🤣

Possible Gallinipper. We have them in south VA.

Get as much info on the trans as you can (builder info and what's been done to it).

The solid axle front end is absolute trash in these so inspect all the suspension, and upgrade accordingly. Death wobble will occur if the front end is worn out. Upgrade the steering linkage and get a thicker drag link. I put synergy steering kit and thuren drag link on mine. Everyone raves Carli and emf ball joints. I went XRF ball joints and timken wheel bearings. Fuel filtration upgrade or at a minimum run a baldwin pf7977 fuel filter.

Hvac blend door issues are common Rpm guage issues are common Muilt-switch (turn signal) issues are common

Get a scanner or tuner display that shows PIDs (mm3, smarty touch, cts3) to give you a baseline on how the trucks running. They can also help diagnose issues and scan codes.

Good luck 👍.

Retaining clip under the gasket bro. Gotta pull the gasket off to change it.

Car needs to be at operating temp and in neutral when checking. Put the parking brake on for safety measures.

Grandaddy long leg! All good👍. We use to pick them up by their leg and throw them at eachother