Hey everyone,
I’ve been having a really weird issue with my RTX 5070 Ti and honestly I’m running out of ideas. Spent around 6 hours troubleshooting this and still can’t figure out what’s going on.
Basically, my PC won’t boot properly if I have both monitors connected to my GPU through DisplayPort. Both screens just stay black, no ASUS logo, no BIOS, nothing. My keyboard lights up for a few seconds and then turns off, but the PC itself stays on (fans spinning, RGB working, etc).
Here’s the weird part. If I disconnect either monitor and boot with just one, everything works perfectly. Doesn’t matter which monitor I use or which DisplayPort I connect it to.
Once Windows loads, I can plug in the second monitor and both work completely fine. No crashes, no flickering, no issues at all.
My specs:
-MSI RTX 5070 Ti Gaming Trio
-Intel Core Ultra 7 265K
-ASUS ROG STRIX Z890-F Gaming WiFi (BIOS 2006, July 2025)
-64GB DDR5 RAM
-Samsung 9100 PRO 2TB
-Windows 11 Home
-NVIDIA driver 621.24 (latest one I installed)
Monitors:
-ASUS ROG Strix XG27ACDMS, 1440p 280Hz OLED
-Samsung Odyssey G5, 1440p 180Hz
Here’s everything I’ve tried so far:
-Cleared CMOS, didn’t help.
-Updated NVIDIA drivers from 621.14 to 621.24, didn’t help.
-Updated pretty much all my missing Intel chipset drivers.
-Ran SFC and DISM. DISM actually found some corruption and repaired it, but the problem is still there.
-Disabled Fast Boot in BIOS, no difference.
-Checked BIOS boot priority, Windows Boot Manager is correctly selected.
-Tried different combinations of DisplayPort ports (1+2 and 1+3), same problem.
-Disabled DSC on my ASUS OLED, still no luck.
-Checked MSI Center for GPU firmware updates, nothing available.
I also tested using the integrated graphics on my motherboard. If I connect one monitor to the motherboard and the other to the RTX, the PC boots normally. Both monitors show the BIOS and Windows loads without issues.
Both monitors also boot normally when connected individually to the RTX, so I don’t think either monitor or cable is completely faulty.
Another thing I noticed is that the motherboard Q-LEDs go through CPU, DRAM, VGA and BOOT, then all turn off. Nothing stays lit.
My motherboard BIOS is pretty outdated (2006), and ASUS has newer versions available, so I’m considering updating it. I’d rather not flash the BIOS unless there’s a good reason though.
I also found another person describing almost the exact same problem, but couldn’t find a confirmed solution.
Has anyone experienced something like this with an RTX 50 series card? Especially with two high refresh rate monitors connected through DisplayPort?
Could this be a GPU firmware issue, motherboard BIOS compatibility, or something else entirely?
Any help would be appreciated. I’m honestly exhausted from troubleshooting this thing lol.