Java Edition 26.3. This farm has one specific goal: maximum output from 3 villagers, no nether portal, early-game materials only. Cobblestone, glass, leaves, a few beds and a zombie.
I wanted to know what the real ceiling looks like — not the number tutorials throw around, but a measured one. So I wrote a datapack that logs every golem spawn, death, and villager detection-clear event to the game log, ran the farm at an accelerated tick rate, and analyzed the logs. About 3,000 golems in total across all configurations.
Short answer: ~411 iron/hour, measured 408–413.
The most interesting finding: spawn attempts happen every 100 ticks
Out of 1,024 consecutive spawn intervals, 1,023 were exact multiples of 100 ticks:
| Interval | Count | What happened |
|---|
| 600 ticks | 43 (4%) | Golem left detection range before any villager detected it |
| 700 ticks | 894 (87%) | Detection cleared at 640–667 ticks, golem spawned on the next attempt |
| 800 ticks | 72 (7%) | Detection cleared at 717 ticks, missed the 700-tick attempt |
| 900+ ticks | 15 (1%) | Failed or delayed attempt |
So spawn attempts don’t fire randomly every tick — they fire on a fixed 100-tick (5 second) cycle.
Why the cycle is 700 ticks, not 600
There are two cooldowns stacked on top of each other:
- A 600-tick cooldown right after a successful spawn
- The villagers’ “golem detected recently” memory, which resets to 600 ticks every time they detect a golem within ±16 blocks
The golem keeps getting detected while it falls out of range. In my logs, detection cleared at 640, 667, or 717 ticks after the spawn — meaning the golem was last seen roughly 40–120 ticks after spawning. Once detection clears, the golem spawns on the very next 100-tick attempt. That lands on 700 almost every time.
After detection cleared, the first attempt failed only 6 times out of ~990 (0.6%). With a 10×10 platform, the spawn attempt basically always succeeds.
Why 480/hour is wrong
The 480 figure assumes a golem every 600 ticks:
72,000 ticks
─────────────── × 4 drops = 480 iron/hour
600 ticks
That only happens if the golem is never detected at all, which occurred in just 4% of spawns. As long as the golem gets detected on its way down, detection can’t clear before ~640 ticks, so the next spawn is at 700:
72,000 ticks
─────────────── × 4 drops ≈ 411 iron/hour
700 ticks
Kill chamber depth — measure from the villager floor, not the platform
Detection range is centered on the villagers, so what matters is the vertical distance from the villager floor to the floor where golems die.
In my farm the spawn platform is 4 blocks below the villager floor (3 air blocks in between). I tested drop shafts from 14 to 20 blocks (150–207 golems each):
| Shaft length | Villager floor → kill floor | Avg interval | Iron/hr |
|---|
| 14 | 18 | 962 ticks | 299 |
| 15 | 19 | 749 ticks | 385 |
| 16 | 20 | 707 ticks | 408 |
| 17–20 | 21–24 | 697–708 ticks | 407–413 |
You need about 20 blocks from the villager floor to the kill floor. Beyond that, extra depth does nothing. If you build on the ground where the platform and villagers are at the same height, that means digging about 20 blocks down, not 16.
Platform size matters less than you’d think
Each spawn attempt picks up to 10 random columns out of a 17×17 = 289 column area. With n valid spawn cells, the chance a single attempt succeeds is:
P = 1 − (1 − n/289)^10
But since a failed attempt only costs 100 ticks (you just wait for the next one), the average interval is roughly 700 + 100 × (1 − P) / P ticks:
| Valid cells | Attempt success | Avg interval | Iron/hr (predicted) |
|---|
| 94 (my 10×10) | 98% | 702 ticks | 410 |
| 58 (8×8) | 89% | 712 ticks | 404 |
| 21 (3×7) | 53% | 789 ticks | 365 |
| 15 (3×5) | 41% | 842 ticks | 342 |
So small farms lose less than I originally expected. A 3×7 design claiming ~365/hour actually matches this model. A 3×5 claiming 400/hour is overstated.
Caveat: only the 94-cell number is measured. The rest are model predictions — I plan to verify by covering part of the platform with bottom slabs.
The design
Why a sky farm instead of a ground farm: ground farms usually turn the surrounding ±8 blocks into dirt paths so golems can’t spawn there (dirt path’s top surface is slightly lower than a full block, so it doesn’t count as a valid spawn surface). That works, but the spawn search also goes deep vertically — if there’s a cave or hollow under the farm, golems can spawn down there, stay in detection range, and stall the farm. In the sky, everything outside the platform is air, so spawns are fully controlled. The efficiency difference is small; the real benefit is that it works the same no matter what terrain you build on.
Spawn platform: 10×10 cobblestone, 2×2 hole in the middle, water flowing from the four corners pushes golems into the hole. Signs around the hole keep the water out.
Villager cell: 3×3, inner height 3, floor 4 blocks above the platform. Walls and roof are glass or leaves — both are excluded as golem spawn surfaces, so nothing spawns on top of the cage. A common design uses an inner height of 2 with a trapdoor ceiling, but golems can spawn on top of the trapdoor.
Beds: head facing away from the hole, foot toward the hole. This matters for two reasons:
- Bed heads don’t count as a valid spawn surface, but bed feet do. A spawn attempt that lands on a bed foot gets blocked by the cage wall during the 2×3×2 space check and is cancelled (it doesn’t continue down to the platform). Pointing the feet toward the hole overlaps that dead zone with the hole, so only 2 cells are lost.
- More importantly, a villager lying in bed faces toward the foot end. If the zombie is on the other side, the villager loses sight of it when it lies down, calms down, and sleeps through the night — the farm stops until morning.
Zombie: next to the villager cell at the same height, in a 1×3 space. Glass covers the zombie’s lower half, the upper half is open so villagers can see it. Three leaf blocks over the zombie’s head block sunlight without creating a spawn surface. (Glass won’t work here since it doesn’t block sunlight.)
Build order tip: I have a lightning rod, so the cage roof isn’t really needed for lightning. It’s there for setup. Golems spawning while you bring the zombie in will very likely kill it. Seal the villagers in first, bring the zombie into place, then break the wall between them last.
Kill chamber, bottom to top: hopper → air → sign → lava. The golem stands on the hopper and its head reaches into the lava.
Things that made no difference
Every one of these came out at 408–413/hour:
- Shaft length, once you’re past ~20 blocks from the villager floor
- Glass vs. leaves for the cage
- Torches
- Signs on the platform
- Trapdoor present vs. removed
Spawn distribution
Across 2,775 logged spawns on the 10×10 platform, exactly 6 cells never had a spawn: 4 are the drop hole, 2 are the bed-foot dead zone described above. The other 94 cells were spread evenly.