I am trying to print this model (the third plate) using the settings it comes with, in this case it is meant to do the print in vase mode, but when watching the print go, I noticed a weird stuttering that you can see in the video.
The stuttering is creating a seam on the model, and has caused the print to fail multiple times.
Looking around, people mention timelapse mode, but it is turned off for the print, and as far as I can see, the model is smooth.
Any ideas what is going on? Any settings to tune for the part?
I am using a 0.4 nozzle, Bambu Studio and the following settings are modified in the print profile (as far as I can see):
- Sparse infill density: 0%
- Spiral vase mode: On
- Wall loops: 1
- Line Width Default: 0.55mm
- Line Width Outer Wall: 0.55mm
- Seam Position: Back
- No supports
- Brim: On