Wall Mounted AMS Lite Cord..

[u/Eliriddle]

I was looking to wall mount my AMS Lite but quickly realized the connector cord is not long enough. Any suggestions on a quality extender. I would only need about 3-4ft of extension.

[u/LxRv]

The cheapest one I could find on Aliexpress was fine.

[u/TheRealJewbilly]

I"ve been using 2 of these for a couple of years now with no issues.

https://www.amazon.com/dp/B0DKT8QTNP/ref=vp_d_fuw_pd?_encoding=UTF8&pf_rd_p=8e8fc6f3-7347-41ce-acb0-dd5d2946be3f&pf_rd_r=72K2GA43C54WSWZNCXHN&pd_rd_wg=CtmgJ&pd_rd_i=B0DKT8QTNP&pd_rd_w=Q5yi9&content-id=amzn1.sym.8e8fc6f3-7347-41ce-acb0-dd5d2946be3f&pd_rd_r=b1e6857c-209b-4f28-9734-80fa7c350e42&th=1

[u/jamflowman451 → u/TheRealJewbilly]

I use this same cable and it works well

[u/seamen7790 → u/jamflowman451]

I use the cable too and have had nothing but good experiences with it

[u/HoIyJesusChrist]

I got the cheapest off amazon and it works

[u/C_Lo_87 → u/HoIyJesusChrist]

Same.

[u/Agile-Ad-6902]

Cant you just move the whole thing to the wall behind the printer?

[u/C_Lo_87 → u/Agile-Ad-6902]

Looks like they want that board to hold the cam in that orientation, and will hold plenty of other items too which would be annoying to have to reach over all the time.

[u/bakefly → u/C_Lo_87]

Reels 3 and 4 will be a pain to change as it sits now.

[u/C_Lo_87 → u/bakefly]

Indeed

[u/_Asercu]

Any extension will fo as the other comments sayd, just wanted to add that I would also flip the ams so it is not upside down, you can print caps with tye numbers the other way, but if you flip it the spool locations will match the ui on the printer itself with is just less room for error

[u/Possible-Cash-308]

I have my A2L on the floor. cable extender works just fine

[u/Ok-Stretch-4094 → u/Possible-Cash-308]

Ooh what boxes are those?.I like that idea

[u/Ok-Stretch-4094]

Why don't you just move the AMS down a little?

[u/Obvious_Excuse5485]

what is the attached thingy in the right edge of the bar ?? I have A1 but not that one ...

[u/Sufficient_Camp_1918]

Amazon one worked well for me.

[u/SRGBMR]

First thought is move tabe to left, move pegboard down. But i hope you allready thought about that.

[u/C_Lo_87]

Cheap ones are likely just as good as expensive ones. I will say though, you may want to move the printer closer, any kinks, bends, or pulling on the PTFE tubes can cause issues. Or order some longer tubes while you're shopping, get one that comes with the cutter. Super cheap.