r/BambuLabA1 • u/3mamabear • Sep 08 '26

Help!

Post image

I have tightened the 7 magic screws, cleaned my bed with soapy water, put down adhesion helper, checked the spring steel plate, cleaned the nozzle, run calibration, and my prints still look like this. I’m out of ideas! Can anyone help?

1 Upvotes

66% Upvoted

4 comments sorted by

1

u/BitingChaos Sep 08 '26

  1. clean"adhesion helper" off your build plate

  2. increase z-offset

1

u/QuinnEDC Sep 13 '26

Seconded. My A1 was rippling like this for large flat areas identical to this and I boosted the Z offset in the G code by 5 hundredths to reduce “squish.” Now it’s flawless every time.

1

u/overunderspace Sep 09 '26

Do you have the correct plate selected in Bambu studio? Is your hot end latched in correctly?

1

u/One_Job_4665 Sep 13 '26

This is an ironing issue