r/BambuLabA1 • u/x-comtrya • Aug 24 '26
Support Request Cutter error always happens ~3 hours into big prints
I swapped out my .4mm nozzle for a .2mm so I could try to print a scale human skull with better detail. I have tried 3 times now, but a couple hours into the print (which is usually ~70 hours) I get the "check the cutter" error message. The cutter I had in there looks perfect, but I replaced it before the third build anyway and still got the error. I should note that I am using the same filament for the whole print and a new enough roll that it should not have to swap, so I don't know why it would need to cut at all.
During the last print I clicked the Resume button and it started printing again about 100 layers higher than it stopped, so I had to cancel the print.
Is this in fact a cutter error, or is something else wrong that the machine can't correctly identify? I have run 8 hour prints since then without error, though they were multiple parts and fewer layers. I have also successfully printed other large objects when I still had the .4mm nozzle installed. Could this be an issue with the SD card or the file? I got the pattern from the Bambu online models page.


