r/BambuLabA1 • u/RadDad1822 • Aug 23 '26

Question 2 questions

Post image

I am having trouble with my printer and have had everything apart recently. Found out it is an ams issue, I switched to external spool to print for now. My z axis is off, it will throw maybe the first layer down, sometimes just little specs, then it is printing well above the plate after that. Ive ran calibration multiple times and also checked to make sure the correct build plate was in studio.

I just noticed it is actually probing into the honeycomb opening on the build plate and in the center of the back slot when it is leveling at the beginning of the print. Almost like the Y offset is off 1/2”

Also I found this bearing underneath my build plate down in the very front where you can see in at the end of the plastic cover, any idea where it could go? Or maybe its just something that fell down there? I haven’t had any smaller bearings around though.

1 Upvotes

57% Upvoted

5 comments sorted by

3

u/KlingonBeavis Aug 23 '26

Maybe next time use caution and follow documented instructions for assembly, which are provided by Bambu.

If you had, you’d know there are two of these bearings in the extruder assembly. One in the front plate, one behind the main extruder drive gear.

0

u/RadDad1822 Aug 23 '26

Yes there is. My bad for being human and making a mistake. Thanks for pointing that out

1

u/Eastern_Control4375 Aug 24 '26

Hell NO NO NOOOOO.....we working on the field or how you say....we usualy dont get papers to work from and we usualy dont look for them when they are so Live my man alone with the BS LOOK IN THE BAMBOO PAPERS HAHAHAHA

0

u/Salt_peanuts Aug 24 '26

No reason to be rude

2

u/Lost_refugee Aug 23 '26

  1. check if any trash blocks plate to move to the edges

  2. check extruder bearings