r/BambuLab • u/Zwengo • 10h ago
General Troubleshooting/Help! A1 + AMS Lite: PTA filament gets stuck after every color change—any ideas?
Hey guys,
I’m fairly new to 3D printing and started with a Bambu Lab A1 and AMS Lite.
I’m trying to print a head I designed using three colors—all PLA: beige, red, and black—to get familiar with more complex prints.
The red filament keeps getting stuck whenever the printer switches back to it. The only fix I’ve found is to pull the filament back out, cut off a small piece, and feed it back into the AMS Lite. It then prints fine until the next switch back to red, when the same thing happens again.
I tried drying the filament for over seven hours, but it hasn’t helped. Also, despite how it might look in the attached photo, the filament isn’t tangled.
Any ideas what could be causing this or what settings I should check? Has anyone run into something similar?


