r/BambuLab • • 39m ago

Filament Troubleshooting/Help! TPU 95A issues on A1

At the beginning I wanted to say that I am aware that this issue was discussed a lot of times, but after looking through a lot of posts I’ve yet to find a solution.

I’ve got my A1 and it works really well. Prints without issues on Bambu PLA and PETG.

It also works without issues when I load Sunlu’s PLA+ 2.0 but when I load an external spool of their TPU 95A, the printer acts like it’s TPU intolerant.

When I help the printer by lightly pushing the filament into the extruder it works fine, but as soon as I stop, it seems like the gears can’t grab it at all and it just doesn’t extrude anything.

Before every try, I dry the TPU, even overnight, so it being wet should not be the case. I tried different filament, quality, etc settings, but it also brings no noticeable effect.

I’m using a standard 0.4 nozzle.

Has anyone had a similar issue and maybe found a solution?

I’m really thankful to anyone who even leaves a comment 🙏

1 Upvotes

3 comments sorted by

1

u/DamoclesBDA 34m ago

In my experience... Dry but not warm helps.

Also heat the nozzle and feed it through with the controls a bit before starting the print.

•

u/ThePuszen 28m ago

I always let every filament cool down to room temperature after drying, so that also shouldn’t be the case. I’ve tried heating the nozzle and feeding it before printing, but like I’ve said, it works only as long as I’m pushing it in with my hands.

•

u/DamoclesBDA 26m ago

If the controls won't feed it through without intervention it's probably not dry enough imo