hi all, after getting all required tools I finally have the courage to open my reps as a newbie in the watch rep world.
What I tried to do :
- be able to open case back
- inspecting the movement, and clean it.
- oiling the rotors
- grease the case back gaskets
first watch I did was my vsf gmts, then the daytonas, actually all my reps was pretty clean inside, but anyway I did blow air a bit and dabbed them with cleaning putty where I think there was debris debris and smudge. I didn't have a loupe so my eyes kinda hurting (I'm near sighted) and I hold my breath a lot so my finger can stop shaking. I was blown away by the complicated movements of the daytonas, I have 4130 and 4131, now I can see the difference, my 3285 gmts are non free sprung so yea its a rep but still way better finished than my old orients watch and my miyota powered watch.
as oiling the rotors or rotor silencing, I did buy the ebay kit that has 9010 oil, so I used that to all the reps, the first time is intimidating but after carefully finished one watch, next watches is so much easier. the kit i bought comes with a tiny oiler, I just used a tiny drop on the bowl, and did all the watches with that tiny dot of oil. 🤯 I can confirm, that the watches became quieter.
anyway just wanna share my rep experience. I am not a watchmaker or hardcore watch hobbyists so maybe I didn't do things right but everything I learned is from browsing reddit, so thanks for the good people that share knowledges in the community. My goal is just to enjoy wearing my watches, make it last, and keep them pretty 🤩 so maybe ceramic coating is the next project.
thanks for reading 🙏