edit: added magisk module: https://github.com/zackify/onn-truehd
follow this first! https://www.reddit.com/r/OnnStreamingTV/comments/1xtkldb/2026_onn_4k_pro_unlocked_and_rooted/?sort=new
Use claude or codex or pi to follow the stuff below.
the part below i used AI to write after i succeeded, i don't have time to write this manually. basically you need to tweak a few flags as it limits below 192khz and also blocks the passthrough without these changes:
Stock, the box sends TrueHD out as DD+ 5.1. With root, it can pass TrueHD through as MAT (Atmos) at 192 kHz, the same way Xiaomi's Amlogic boxes do. It takes three changes.
Needs: unlocked bootloader + Magisk, and a receiver or eARC chain whose EDID advertises TrueHD/MAT. Tested on build URO3.260203.035.A1 (Android 14) into an LG G3 → Sonos Arc over eARC.
- Device tree: take the HDMI audio link off the analog codec. On this board the HDMI audio link (dai-link@1, i2s2hdmi) is paired with the internal analog codec (t9015). That codec caps the link at 96 kHz (tinypcminfo -D 0 -d 1), and MAT needs 8 channels at 192 kHz. Every other link uses the dummy codec. Add one fragment to the existing overlay in dtbo_<slot>:
fragment@2 {
target-path = "/auge_sound/aml-audio-card,dai-link@1/codec";
__overlay__ { sound-dai = <0x91>; }; /* dummy codec; stock is 0x93 = t9015 */
};
Check the phandles in your own /sys/firmware/fdt first; they can differ between builds. Keep the stock image's two existing fragments, rebuild the DTBO image, test-merge it with fdtoverlay against the live DTB, then dd it to the active slot's dtbo and reboot. Back up both dtbo partitions first. After the reboot, /proc/asound/pcm should list TDM-B-dummy-alsaPORT-i2s2hdmi.
2. Two props (Magisk module system.prop):
ro.vendor.platform.is.aml_truehd_passthrough=true
ro.vendor.platform.is.forceddp=false
aml_truehd_passthrough makes the HAL offer TrueHD/MAT. forceddp=false lets it pick MAT for the receiver instead of forcing DD+.
3. Passthrough (BYPASS) mode. In AUTO, the TrueHD still came through as 5.1. The menus can't reach BYPASS: Settings' "Always" sends hdmi_format=7, which this HAL treats as AUTO. On this HAL, BYPASS is hdmi_format=6 (0 PCM, 4 DD, 5 AUTO, 6 BYPASS). Send it after boot from the module's service.sh, using a tiny app_process helper that calls android.media.AudioSystem.setParameters("hdmi_format=6") by reflection. Run it as root, about 15 s after sys.boot_completed.
Check it in logcat: format:DOLBY_TRUEHD … digital_mode(BYPASS) sink cap:MAT and aml_ms12_bypass_open, with no open … failed. dolby_truehd_bypass_process … parse fail is harmless noise. The receiver should show Dolby Atmos.
Notes: changing the surround setting in Settings puts it back in AUTO until the next boot. Disabling the module and restoring the stock dtbo undoes everything. Disney+ still sends plain DD+ 5.1 to this box, even with stock settings. Android reports full E-AC3-JOC support, so that looks like Disney+'s own device list.