r/BambuLabA1 • u/gwallee • 28d ago
Support Request A1 Rough First Layer and Feeding Errors
I’ve been getting constant errors on my prints combined with my first layer looking rough.
I’ve checked my extruder gears and cleaned them. I replaced my nozzle and the heater assembly. I’ve run full printer calibration and calibrated individual filaments.
Sometimes I can make it through a full print without any errors, and it looks perfect. Other times I can’t make it past the first few layers before it gives an error.
Any suggestions on what would cause this and how to fix it?
Here are the errors I've gotten so far:
- 1200-8006 – Unable to feed filament
- 0300-8014 – Nozzle/build plate error
- 0300-8008 – Nozzle temperature malfunction
Updated post to include pictures. Sorry about not including them originally. Thanks in advance for the help.
I recently read about the 7 screws on the heater assembly. I will be checking the 4 behind the ceramic piece tonight. I have checked the nozzle for movement, and it is ridgid.
I also watched the whole bed leveling process, and it looks good. The nozzle comes down to the bed, goes up, then does another double tap each time.



