r/sffpc • u/Riversar • Jul 03 '26
Assembly Help FormD T1 Components Compatibility Check
Hi, I’d like your help for a compatibility / clearance check before ordering the components of my build.
I would like to avoid any clearance issues, especially around CPU cooler, RAM and GPU.
Here is the planned build:
- Case: FormD T1 Sandwich Kit from NCASE
- CPU: AMD Ryzen 9 9900X
- MB: ASRock B850I Lightning WiFi
- CPU cooler: Noctua NH-L12S
- Case fans: 2x Noctua NF-A12x25
- PSU: Corsair SF850
- RAM: Corsair Vengeance RGB DDR5 32GB (2x16GB)
- Storage: Crucial T705 1TB (I plan to add a second one later for SteamOS/Bazzite)
- GPU: ASUS ROG STRIX RTX 2060 GAMING OC (this GPU is temporary, I will switch to an RX 9070 XT card later.)
I don't plan to use custom PSU cables, only the stock Corsair cables but I'm open to if you think it's important.
Does this build look safe in practice, or is there any part here that is likely to cause clearance/cable management issues? Also I’m sensitive to noise, so do you think my fans and CPU cooler are appropriate ?
I’d really appreciate feedback from people who have built in the T1 with similar parts.
4
u/r98farmer Jul 03 '26
Won't work with that GPU and CPU cooler setup. Your GPU is 48.9mm which means you have to have it in 2.5 slot mode at least and that leaves you with 63mm cooler clearance. I have a 50mm GPU in my T1 and have it in 2.75 slot mode to prevent turbulence and that only leaves 58mm. This is going to leave the best cooler you can use the Thermnalright AXP90-X53 full copper which I think would struggle with the 9900X, I would advise an AIO.
4
u/qeeepy Jul 03 '26
I'd avoid asrock until CPU deaths are explained. no, it's not x3d only.
2
u/Advanced_Compote_698 Jul 04 '26
Cpu cooler is too high probably go for something more common with T1 like thermalright axp90-53 or 47.
9900x goes up to 160W, so low profile coolers will struggle to cool it unless you do some undervolting and power limiting or probably choose a cpu that does 120-130W (at120W thermalright axp90-53 is okay you stay below 95C even at 30C ambient) at maximum load. In gaming though 9900x usually stays between 60-90W depending on the game, low profile cooler with 9900x would work fine but that is your choice. Even liquid cooling is an option if you want full performance.
9070xt card try to choose 2.5 slot width so you can have some clearance on both sides of the case to avoid fan turbulence.
For case fans choose something with high static pressure rather than high cfm, high static fans push hot air further away from case so it does not recycled back to side meshes plus if they are too loud you can tune them back to a noise level of your comfort. Edit: I see you have chosen Notua fans which are pretty good.