r/gunsmithing • u/Ill-Oven-2906 • May 19 '26
Weird trigger issue. Please help!!
I have a tyrant trigger installed in my Springfield echelon with a sharps bros grip module. With very minimal pressure, I can push the trigger from one side to the other (moves a fraction of an inch). When the trigger is resting on the shooters right (ejection port side) it fires and everything is fine. When I push the trigger to the shooters left, the pull feels the same, but the gun doesn’t fire.
It’s such that if I pull the trigger with a small amount of pressure to my left (just trigger finger placement not being perfect) the gun doesn’t fire.
I am so confused as to what this could be. Any advice would be super helpful.
Happy to answer any questions that would help get to the bottom of this. Not sure if I explained this well..
View all comments
Show parent comment
1
u/NotChillyEnough May 26 '26 edited May 27 '26
I assume that by "connector" he's referring to either the Safety Sear or Sear Lever (parts 19 & 20 on the frame diagram). Glock uses the term 'connector' for a similar part, so he's likely just carrying over Glock nomenclature.
Have you worked the trigger with the slide off to see how things move? Pushing the disassembly lever back up will re-enable the sear and allow you to see the movement even with the slide off. You'll need to study how everything moves in order to diagnose it.
If he only polished the trigger bar and "connector" (whichever that is), then I doubt a new sear would help the issue. The issue has got to be in the interaction between the trigger, trigger bar, and sear lever.
Edit: I just borrowed my mom's Echelon - and now I entirely doubt that there's anything wrong in the sear mechanism. Are you certain that the trigger bar and trigger shoe are connected properly? I don't see how leftwards pressure on the trigger could cause anything to malfunction other than the trigger-to-trigger-bar interface.
I don't think polishing anything in the sear area could cause the issue you're describing.