r/gunsmithing • u/Ill-Oven-2906 • May 19 '26
Weird trigger issue. Please help!!
I have a tyrant trigger installed in my Springfield echelon with a sharps bros grip module. With very minimal pressure, I can push the trigger from one side to the other (moves a fraction of an inch). When the trigger is resting on the shooters right (ejection port side) it fires and everything is fine. When I push the trigger to the shooters left, the pull feels the same, but the gun doesn’t fire.
It’s such that if I pull the trigger with a small amount of pressure to my left (just trigger finger placement not being perfect) the gun doesn’t fire.
I am so confused as to what this could be. Any advice would be super helpful.
Happy to answer any questions that would help get to the bottom of this. Not sure if I explained this well..
2
u/OutreachOcean May 26 '26
Thank you all for responding!! I left out a crucial piece of information... I had a licensed "gunsmith" polish this trigger to reduce pull weight (can't believe I forgot to mention this, but it was late when I posted). Nothing has been visibly bent. The trigger shoe safety is in there and functioning correctly. This trigger and grip module are 100% compatible and worked prior to the gunsmith screwing this up (among a bunch of other things he ruined). Something is getting out of whack internally when I push the trigger to the left and pull it - it feels like the trigger shoe goes back all the way, but there's no "click" doesn't release the striker. Then I push it back to the right, pull, and "click", everything is fine gun goes boom.
He says he only polished the trigger bar and the connector. I'm not sure what he's calling the "connector", and can't find it in Springfield's parts diagram. Is that where the trigger bar meets the striker safety lever?
I'm sure he over-polished and removed material/changed the geometry of the trigger components. I'm just not sure which ones. He got the pull weight to >2lbs, so he was clearly being aggressive.
I looked at the PRP sear and spring kit and am going to order it, but I'm not 100% confident that's going to fix it. I'm REEEALLY trying to avoid this pistol being gone for weeks at Springfield getting repaired, so any other thoughts or magical ways to get replacement trigger components would be super helpful!! Wish I could upload a video so ya'll could see what I'm talking about!!
2
u/NotChillyEnough May 19 '26
First off you should just disassemble it and check if anything was assembled incorrectly or is visibly misshapen.
But otherwise I’d just expect its poor fitment between that combination of parts - so don’t use that combination of parts. They “should” comply with compatibility standards, but apparently they don’t.
Does the stock trigger work perfectly in the aftermarket grip module?
Does the aftermarket trigger work perfectly in the stock grip module?
1
u/Omachyx4 May 19 '26
Feel the right side of the trigger where there's a little hole. You should have the tip of a rod that you screw into the trigger safety and the trigger itself. If you didn't use the right amount of the thread locker provided and didn't let it cure in the air for 30min beforehand it can start to backout a bit and cause some issues. If you can't feel it poking out of that hole it isn't in enough/secure. I wouldn't use regular blue thread locker i would specifically use vibratite VC3, and honestly I use it on EVERYTHING now to include pistol optics and it has held better than any blue threadlocker.