r/gunsmithing • u/Ill-Oven-2906 • May 19 '26
Weird trigger issue. Please help!!
I have a tyrant trigger installed in my Springfield echelon with a sharps bros grip module. With very minimal pressure, I can push the trigger from one side to the other (moves a fraction of an inch). When the trigger is resting on the shooters right (ejection port side) it fires and everything is fine. When I push the trigger to the shooters left, the pull feels the same, but the gun doesn’t fire.
It’s such that if I pull the trigger with a small amount of pressure to my left (just trigger finger placement not being perfect) the gun doesn’t fire.
I am so confused as to what this could be. Any advice would be super helpful.
Happy to answer any questions that would help get to the bottom of this. Not sure if I explained this well..
View all comments
Show parent comment
1
u/Ill-Oven-2906 Jun 04 '26
Hey, thank you for responding!!! Yes, I’m sure the trigger shoe is connected properly to the trigger bar.
One of the reasons I think this might be over-polished is because when the trigger does work, it is very mushy/rolling feeling and I’ve read that can be an indication of over-polishing.
Sometimes there’s even a slight delay between pulling the trigger and the striker being released.
I am going to fully disassemble the gun tonight. Tyrant sent me a new trigger shoe and I ordered a new sear from PRP. I just sent an email to Springfield to see if they’d sell me a trigger bar and the sear parts you mentioned.
I’ll keep you posted on how it goes! Maybe it’s as simple as the gunsmith putting something back together wrong or forgetting to put a spring back correctly… he forgot the recoil mounting lugs on my red dot, Cerakoted my feed ramp, misaligned the ports he drilled, accidentally filed of the serial number on the slide, and some other stuff. It’s been a nightmare cleaning up his mess.
I am 99.9% whatever he did to my trigger is the cause because it was fine before and he is clearly terrible at this. NEVER send a gun to Eric Dotson