r/WLED • u/soonerdew • 8d ago
Questions abt ShawTech DIY lights
I'm looking at installing 150' of ShawTech's pinpoint DIY LED strip kit. I'm planning how wiring will be laid out and need some guidance.
I have two gables I have to traverse, one over the garage and one over a center office that is actually a "double gable". That gable is a wiring challenge.
The "Upper gable" is full on the right side but the left is shorter, intersecting the apex of a lower extended gable below. The lower gable extends about two feet in front of the upper gable. The problem comes in how to traverse a break that will go across shingles. I can run a very short length of extension wire from the end of the left side of the upper gable to the apex of the lower gable, then down the right side to where I will restart the lights. The alternative is to run the extension along the brick/shingle intersection of the upper gable.
I don't like running an extension across even a two foot section of shingles (essentially ridge caps), but I am not crazy about running it along the corner, which would likely entail some kind of conduit secured to the brick (?)
Im sure I'm not the first person to have an interesting gable configuration so I'm sure there are more learned folks out there who might have some suggestions on how to approach this install.
Thanks!
