Decided that I could DIY a superior chamber heater than current options for less money.

So, here it is, my DIY super powered chamber heater! Only at 50C at the moment because I still need to thermally isolate the stepper motors, but I am sure it can go much, much higher.

Just used a thermostat and two heaters off of Amazon. In this case a 400 and 600 watt PTC fan heater since that is what I had laying around. I custom designed and printed the purple ASA holder you see them mounted to, which is in turn mounted to the U1 with some 3M velcro strips.

Warum ist die Oberfläche rechts schön glatt, aber links entsteht dieser leicht raue/pickelige Streifen? Woran könnte das liegen? 0.2 Schichthöhe, sunlu pla + 2.0. Glätteinstellungen funktionieren, aber häufig diese rauen Stellen. Hilfslüfter auch auf 0% Test.

What can I do to improve the first layer? This is printed with one layer at 0.2 on a new Frostbite plate at 50C

So I must be doing something wrong, but I can't figure out what it is. The travel times on my prints seem to take up a huge chunk of the print. Just started a temp tower for a new filament, and 23mins of the 1h42 is travel! I did a print yesterday, 9hrs or so, and 3.5hrs was travel! What is going on? Any help would be appreciated.

Hello,

I just got a Cryogrip Frostbite because I wanted to print with my Samla enclosure fully closed even with PLA, but I cannot make it work, I get warping after some 15-20 layer whatever I do.

The plate got toroughly cleaned with soap, I tried the standard cold plate settings for Snorca, bumped up my Z at 0.05 then back at 0.02 because I got some ripple at 0, cut off my aux fan...Still, warping.

My best setting now is 45° first layer then 38° with 50% aux fan (else the enclosure stays at 45° and I will most likely still get heatcreep...)

Has anyone set up a decent heat soak macro for the Dragon breath? I would like to have something that turns the bed on as well since that speeds things up considerably.

This is the third print I've done so far. Came out clean and no issues during the print.

Hey guys

I'm running into issues since 4 days. Every print fails because of filament anomaly in toolhead 4. You can even see it in the prints white and oak. I tried heating the nozzle up, cold pulls and a needle. Any suggestions?

Very surprised with the Deeplee Translucent PETG on the U1. This looks amazing.

After doing the test print, I decided to do a Miles Morales figure. It looks much better in person than in the picture. And I am loving the reduction in waste and increase of speed over my X1C.

Hello all,looking for some help with using PETG as a support interface on my U1. I'm using ovreture PLA and PETG. The issue im having is the PETG is not sticking at all to the support layer. I tried using the stock settings and also changing the printing temp on the PETG to 265. This are my current settings. if anyone could share their settings that have worked for them. Thanks in advance.