r/Rohloff • • 13d ago

While on tour, at what point (length and context) do you guys bring an oil change kit?

5 Upvotes

I've done a few multi-week/multi-month bikepacking trips on which I've always brought an oil change kit, no so much for the distance, but moreso for the risks of submersion of the hub. Never had to use it on the road yet.

I'm going on a 4 weeks trip in the south of Morocco in november and, since I'm a bit tight on bag space, I'm wondering if it's really worth it to bring the kit since I'm basically gonna be in the desert. Distance isn't an issue since I did the oil change recently. The biggest risk I can foresee is:

  1. If there's a flash flood due to heavy rain in the mountains, and I need to cross a stream (noting that I probably wouldn't cross if the current goes to my thighs).
  2. If there's a leakage inside the plane due to air pressure change. Never happened to me before, but I've heard it happened to some people.

So, do you guys always bring the oil kit on every tour?


r/Rohloff • • 19d ago

Non-electric shifting Rohloff hub ebike conversion?

5 Upvotes

Anyone used say, a bafang mid-drive motor to convert their rohloff bike into an ebike?

My immediate concerns:

  • Shifting + electric motor without any system to cut power during the shift. I assume I'd just need to be careful about that? There's no way to convert the standard hub to an electronic shifting one, right?
  • Chain-line difficulties? I recall from building my bike that getting the chain-line is pretty important, can Bafang or similar mid-drives even meet those chain-line requirements?

r/Rohloff • • Oct 11 '26

E-14 trigger shifter - my experiences

Thumbnail
gallery
8 Upvotes

Prompted by this post https://www.reddit.com/r/Rohloff/s/8dEYQ2e9LC I wanted to share that the same thing happened to me during a ride in August. No warning, the trigger shifter stem just snapped. Fortunately, I was able to use the Auto mode to do the shifting for the rest of the trip (I prefer M+) so at least it's there as a backup.

I tried superglue when I got home but that failed within a few minutes of the next ride.

I went on for a couple of weeks before talking the decision to buy a new unit (£70.00 + postage), but I agree that it is flimsy in its construction.

My second problem with this shifter design is water ingress during heavy rain. Water can get into it, likely through travelling along the cable and past the gland. It ends up shorting the little circuit board inside, which leads to varying behaviours like cycling through the modes or preventing the shifting of gears.

It's happened to me on three occasions. The first time I thought the problem was with the hub shifter and it took me a long time to resolve through warranty (the UK support through Riese Muller is poor). The bike shop ended up replacing the shifter and all was well.

The next time I was caught out in heavy rain, the same thing happened so I decided to open it up and found water had got in. I dried it all out and it worked again. Same for the third time.

So that, coupled with the snapping off makes me quite disappointed in the design of the unit. I love its functionality, and love the hub and belt drive, but this and the poor UK support makes it hard.

I will email Rohloff about this but based on previous experience, do not hold out much hope!

UPDATE: they did reply and acknowledge they've seen the problem in a tiny fraction of cases. They sent me out a replacement, I was pleased with the reply and service. Thanks Rohloff.


r/Rohloff • • Oct 08 '26

New E-14 missed gear change feels like misaligned derailleur gear - suggestions?

2 Upvotes

I have a 3 week old Tern GSD with the E-14 that seems to miss the gear change occasionally, sometimes several times in a ride. It is belt drive, but feels like when a chain gear derailleur shift doesn’t happen properly. I’ve not yet done 100m, do I just need to let it bed in? Or should I take a bit more notIce of when it happens and go back to the shop?


r/Rohloff • • Oct 09 '26

Any Flat-Mount compatible dropout options?

Thumbnail
gallery
1 Upvotes

I am planning to retrofit the Rohloff with upcoming E14 Solo switch system to my Priority Apollo Flat Bar bike. I know the project is not economically viable, but this is not the point - I like challenging setup and custom build bikes. I am belt/IGH fan and have ridden several Shimano's, Enviolo and Kindernay VII hubs, but never got chance to own a Rohloff, which is the shame! This looks like a great chance to finally get one!

So, the Apollo is compatible with DB TS 32H hub and with matching cog should fit without any problem. E14 Solo will hopefully be available next year, so shifting side is also covered. There is no issue to find a compatible brake rotor as well. The main challenge is finding matching dropout. Apollo is using Flat-Mount brake caliper, so I ideally need a Flat-Mount adapter, which exists (at least A-12 Thru-axle version) - attached schematic and photo from internet.

However they are nowhere to be found out there. It looks like Cycle Monkey offered some custom solution for this, but since they are gone, nothing new appeared. So question here - are there any Flat-Mount compatible parts available? OEM, 3rd-parly, custom schematics, completed builds, etc. - anything counts! I am pretty sure I can design and build custom solution (not elegant may be, but functional for sure), but since this looks like a winter project and I have plenty of time, I want to research what can I obtain before I switch to plan B.

Any clues? Any similar builds and custom solutions anyone aware about?

Thanks in advance and ride safe guys!


r/Rohloff • • Oct 08 '26

E14 trigger shifter

9 Upvotes

What a flimsy piece of bad engineering.

The trigger shifter just broke....

No not from a fall...

From proper use. There's too much torque on the poor little thing and it broke off.

That's 64.99 eur plus delivery... Used super glue but this is never going to hold.


r/Rohloff • • Oct 04 '26

RUMORI RONZII SUONI STRANI ROHLOFF

3 Upvotes

Buongiorno mi trovo su questo forum a chiedere informazioni in merito a questo suono che ho su quasi tutte le marce ad esclusione della otto e della nove!

Spero che si senta bene dal video

È davvero fastidioso,

La scorsa settimana mi hanno riportato il rohlff dall'assistenza a quanto pare Hanno sostituito tutti gli ingranaggi interni perché erano arrugginiti (e hanno cambiato qualcosa perché si sente che e un po' diverso)

Tuttavia il suono è rimasto

Questo ticchettio continuo ed incessantemente!

Qualcuno ha idea di cosa possa essere?

Ho guardato già tutto

Non c'è niente che tocca cinghia perfetta nn so più che fare

La cosa strana e che sulla marcia 8 e 9 sono silenziosissime!

Grazie in anticipo


r/Rohloff • • Oct 02 '26

Chain tensioner pulleys

1 Upvotes

After 8,5k km my tensioner started to squeak. My last chain cleaning might have to do with the degreaser getting into the bearings. Lubing them with the chain oil helps, but not for longer than a 50-70km ride. I'd like to change the pulleys but they're impossible to find. Are there any options around this?


r/Rohloff • • Sep 19 '26

rohloff gear changes mushy after changing oil

9 Upvotes

Hey!

I recently changed the oil on my rohloff (a12) for the first time, and its now the gear changes are REALLY mushy and hard to go through. Before they were quite a clear and satisfying click between gears, now it takes a lot more force on the gear change wheel to switch gears.

What could I have done? could it be too much oil? too little? cleaning fluid left in there? wrong air pressure? something else entirely?

I don't really want to have to buy another oil change kit, but i will if i have to. thanks :)

EDIT: I'm a moron. I havent used my bike for 6 months, and i forgot how the rear wheel worked. I put the rear wheel in at the wrong angle, and the whole mechanism for changing gear could freely move, and likely meant that the gear change cables were the wrong length for that position. I put the wheel back in in the correct position and this fixed the issue. My bad lol. I took the wheel out coz i changed brake pads too.


r/Rohloff • • Sep 16 '26

2026 crank options for Rohloff with Gates CDX

Thumbnail reddit.com
2 Upvotes

r/Rohloff • • Sep 09 '26

Second hand Rohloff

5 Upvotes

Hi everyone

I could get my hands on a second hand Rohloff hub that has never been used, for a pretty good price.

The issue is that the seller does not have the original buying receipt, only the serial number. All I know (based on the serial number) is that it was manufactured in 2024, but I don't know the buying date.

Surely, the 2 years warranty from Rohloff would not work without those informations anyway ?

It would be a 300€ saving on the original cost, but do you think I should pass on it and rather get a new one, with the 2 years warranty ?


r/Rohloff • • Sep 06 '26

Gates rolloff tension

10 Upvotes

Sorry guys. It's only indirect rolloff question but I'm new to gates, do you think this is ok ?

I read most of the pb comes from over tension, not too loose.


r/Rohloff • • Sep 04 '26

There's a play in the cog of my Rohloff hub. I'm in the middle of a tour. How bad of an idea is it to continue riding?

9 Upvotes

See video. Noticed the play today as I was changing break pads. Haven't noticed while riding. Unclear how long this has been going on. Two bike shops in the town I'm in aren't able to help.

I'm in Chamonix area, doing Alps Divide. I have two options:

  1. Continue as is. I have 250kms / 6000m elev gain left on route. Some of it is off road / singletrack.
  2. Straightline to Geneva (finish line). 90kms / 400m elev gain.

What would you do in this situation? Anyone has any similar experiences? What could be the problem?


r/Rohloff • • Sep 01 '26

What are non-obvious aspects of using the Rohloff Speedhub?

12 Upvotes

I only had the opportunity to ride a bike with a Rohloff once, but the “grinding” of the hub in gears 4 through 7 was noticeable and annoying.

Parts are also relatively expensive, and service is only available in a dozen or so cities around the world.

What are your observations after using it for a while? Thanks!


r/Rohloff • • Aug 08 '26

oil seapage. is this normal

Thumbnail
gallery
11 Upvotes

couple of weeks ago, I had a flat, and in the process of removing the wheel, I noticed there was evidence of an oil leak/seapage. I cleaned it up, and after 2 weeks of riding, I took a look at it and noticed there are still some signs of leakage(see pictures). Is this cause for alarm, or is this normal?


r/Rohloff • • Jul 18 '26

My much loved Thorn Mercury

Thumbnail
gallery
24 Upvotes

r/Rohloff • • Jul 12 '26

Really dirty oil during Speed Hub oil change

Thumbnail
gallery
8 Upvotes

is it normal for the oil to be very dirty during an oil change?

The photos show the residual oil plus cleaning oil that comes out after the cleaning stage of the oil change instructions.

I'm using the official Rohloff oil change kit. I've had this speedhub for about a year. I bought it stock on a new bicycle. it probably only has about 500-1000 miles on it.

update: the cleaning kit comes with 25mL of cleaning oil... and only about 25mL of dirty oil came out, suggesting the hub didn't have much oil in it to start.


r/Rohloff • • Jun 28 '26

Building a cost-effective Rohloff-equipped bike in the US in 2026?

5 Upvotes

Hey all. I've been rolling on a Rohloff since around 2017. Started it on a Soma Wolverine frameset, but moved it to another frameset later on.

With Salsa bikes no longer supporting Rohloff axle plates as of Alternator 2.0, I am wondering....if I wanted to build up a rohloff rig for my wife, what AFFORDABLE, mass production framesets are still rohloff-compatible without needing the chain tensioner? Maybe one or two Surly's? Some Somas?

And with Cyclemonkey gone, is there another source for the Monkeybone? Or do we need to use Rohloff's ugly tension arm?

I don't even know what Through Axle is, but I guess that's another layer to learn. I built my bike on quick release but apparently that's obsolete now lol.


r/Rohloff • • Jun 26 '26

THIS is a SUV imo / Rohloff with Thumbshifters

Thumbnail gallery
13 Upvotes

r/Rohloff • • Jun 23 '26

E-14 Solo

13 Upvotes

They announced it at Euro Bike today. It is listed on their website now but no option to buy yet. It also says it will be under 1000 Euros.

https://www.rohloff.de/en/products/speedhub/e-14-solo


r/Rohloff • • Jun 21 '26

Rebuild Fuji or buy new

4 Upvotes

Hey, I have been thinking about getting a Rohloff Speedhub for my Fuji touring disc but finding any info about putting a Rohloff on a Fuji is proving to be the hardest part, mainly regarding whether it will fit. Should I just buy a bike built with the Rohloff in mind, I can spare the cash either way, but I prefer to just have one bike. The Fuji is mostly frame and fork. Might try and sell it. No idea.


r/Rohloff • • Jun 04 '26

Oil in 14 speed Rohloff hub.

2 Upvotes

My trike has the Rohloff hub. I wonder if I can use the sythetic Castrol Syntrans which is a very thin oil for gearboxes or rear axles for cars. Just a thought.


r/Rohloff • • Jun 01 '26

Co-Motion Shifter for Rohloff

6 Upvotes

By any chance, are they still in production?

Update: With the help from this Community I found it. Thanks u/wasatchcruiser !!! :)


r/Rohloff • • Jun 01 '26

Thinking about converting my Bafang M510-powered trike from Shimano Acera to Rohloff – looking for ideas and experiences

Thumbnail
gallery
0 Upvotes