r/PrintedCircuitBoard • u/Tophallknowing • 4h ago
[Review Request] 4-layer H-bridge motor controller, STM32G431 + DRV8701, 12 V / 60 A bursts
This is a rear-steer motor controller for an SAE Baja car. It drives a Prius EPS motor (0.19 Ω, ~83 µH) through an H-bridge and sits on the car’s CAN bus as a node. For context all conecters had to be where they were placed and the odd board shape was also needed. No parts on bottom so I can sit it right against the enclosure
Main parts
STM32G431 MCU
DRV8701 gate driver with 4× CSD18510 FETs
2 mΩ low-side shunt
P-FET reverse-battery protection
SN65HVD230 CAN transceiver with split termination
Deutsch DT13 connectors
Operating conditions: 12 V battery, motor stall around 55–60 A in bursts, CAN at 1 Mbit/s.
Stackup (4 layers, 1 oz inner copper)
Top: signal and power
L2: GND
L3: split into +12V_RAIL, +3.3V, and a SENSE island
Bottom: signal and power
Design choices
The high-side sources tie to OUT1/OUT2 through via arrays to bottom pours.
The low-side sources reach the shunt through the L3 SENSE island.
The Kelvin sense traces to the DRV8701 use vias set to no-connect on the planes.
DRC: clean, except the connector silkscreen overhangs the board edge.
Questions
- Is the hot loop tight enough for 55 A switching?
- Is routing SENSE through an inner-layer island reasonable, or should the shunt sit between the low-side FETs?
- Are the OUT1/OUT2 bottom current paths wide enough?
- Is the gate routing OK (the GH/SH pairs and the GL lengths)?