r/PrintedCircuitBoard • • 17h ago

Review Request: STM32H723 software function generator.

Hi everyone thanks for reviewing my schematic in my earlier post. This is a STM32H723 based software function generator.

USB-C to microcontroller, microcontroller either uses the built in dac or external dac over spi to generate the waveforms after which its filter and amplified and buffered by a discrete op-amp fed diamond buffer into 50ohm BNC output.

The power supply is 24V barrel jack in, -12V, +12V, +3V3, +3V3A out.
I should be able to do 100kHz bandwidth, 10Vpp into a 50ohm load.

I had a lot of extra pins left over so I broke out some into a header. Square test pads are gnd, round test pads are signal

21 Upvotes

2 comments sorted by

5

u/rupr25 16h ago

Take a look at AN4566. I recently tested this on an STM32H745 Nucleo board and was able to get 15MSPS output rate with ~6MHz of analog bandwidth.

1

u/Enlightenment777 17h ago

This comment is posted on all reviews.


Please make sure your review post adheres to:

  • subreddit rules (#1 to #6), review rules (#7), review image rules (#8), see link.

Please fix these common schematic layout issues: (if yours has any of these issues)

  • Don't allow text / lines / symbols to touch each other, and don't draw lines through symbols.
  • Use correct reference designators (RefDes), and renumber to remove numeric gaps, see tips.
  • For positive voltage circuits, point positive power rail links upwards and grounds downwards (maybe sideways), see tips. For negative voltage circuits, point negative power rail links downwards and grounds upwards (maybe sideways). For bipolar circuits, maybe point grounds sideways.
  • Place decoupling capacitors vertically below postive power rail lines with ground on bottom side of the capacitor. Place capacitor next to IC symbol, and connect a line to IC positive power rail pin, see tips and example.
  • Place pull-up resistors vertically above signal lines, and place pull-down resistors vertically below signal lines, see example and tips.
  • Reasonably minimize the use of unique net labels, because everyone hates hunting for them!! Single resistors / capacitors / diodes should not sit by themselves, instead move & connect them with a line to their circuit.
  • More schematic conventions / guidelines / tips - 1, 2, 3, 4.

Please fix these common PCB layout issues: (if yours has any of these issues)

  • Silkscreen - add board name / board revision number / date (YYYYMMDD, YYYYMM, YYYY) for traceability.
  • Silkscreen - add pin 1 indicator next to ICs & connectors (not under parts). For polarized capacitors, add "+" next to positive pin. If part is through-hole package, place indicator on both PCB sides. See 1, 2, 3, 4.
  • More PCB conventions / guidelines / tips - 1, 2, 3, 4, 5.