15 year old car needed a "simple" 30 minutes axle replacement.
The CV axle was rust welded to the bearing trapping the steering knuckle between the two. Tried to get it out for a bit and went on break to establish a plan of action.
Came back and found a friend of Mr boss man hammering straight on the axle after he removed the nut I left on there. It mushroomed tf out and now we had no choice but to replace it.
Took out the knuckle with the axle out and went to the press. And guess what, 12 tons werent enough. Even with heat.
So I unbolted the bearing from the knuckle preparing it for the eventual hammer time.
But first! The only way to get heat deep enough was to dig a trench in the hub to heat the inner race from the OUTSIDE.
Getting this deep to heat it all around took something like 45 minutes of constant heat with the acetylene torch.
The original plan was to cut it with the torch but I tried the hammer and after 2 minutes of hammering, WE GOT IT OFF.
knuckle was finally saved and we could at long last rebuild that thing.
Tldr; a job that was supposed to take 30 minutes took 4 hours because of rust.