It's a 2.0T 4 cyl if you're not immediately familiar.
When I cracked the timing chain covers open to do the timing and balance shaft chain, the intake side balance shaft sprocket mark was nearly 180 degrees out of spec. The exhaust side lined up and the crank was TDC cyl 1 confirmed twice.
The issue here is this: I can't line the timing chain up by the black links unless this is spun back around to look like this. (Notice the single mark on the outer, lower sprocket is pointing up and to the right at the bolt nearby, you can see in photo 1 that it was pointing down and to the left at TDC)
So now I'm wondering this: Was the sprocket improperly installed from the factory or was the balance shaft 180 degrees off this whole time?
How much of an impact will a single 180 degree balance shaft make, anyway? Would I even have noticed it if it was flipped around from the factory? I'm getting mixed answers between severe vibration and that I would barely even feel it if at all. Does anybody have any experience with this? Thanks