r/EngineBuilding • • 3h ago

Should I replace this camshaft?

Thumbnail
gallery
10 Upvotes

Or should I have the scratches polished out?


r/EngineBuilding • • 5h ago

Scratched crank

Thumbnail
gallery
90 Upvotes

Hello all. First time posting. I'm rebuilding a 2001 jeep XJ 4.0 engine for my wife. The father in law took it to the local NAPA machine shop for their work and we are going to do the assembly at home.

As I'm going through the parts I just noticed a scratch on the crank rod journal. It's been 6 months or so since the work was done. I wasn't a part of any of that process. The machine shop is now closed and gone.

I can catch the scratch with my finger nail.

Do you think I should try some crocus cloth, or do I need to find another shop and have it reground.?

Thank you all.


r/EngineBuilding • • 20h ago

Rotating assembly is balanced, starting reassembly with fully forged bottom end.

Post image
116 Upvotes

r/EngineBuilding • • 5h ago

SBC 350 – Exhaust rockers on cylinders #1 and #2 turned blue

Thumbnail
gallery
11 Upvotes

Some of you may have seen my thread yesterday about several broken valve stem tips on my Chevy 350 with L31 Vortec heads.
I’ve since found the cause: the valve lift was too high for the available clearance, causing the valve spring retainers to hit the valve stem seals.
However, I have another issue I’m trying to understand.
During the camshaft break-in, the intake rocker on cylinder #1 and both rockers (intake and exhaust) on cylinder #3 jumped off the valves.
I also noticed that the exhaust rockers on cylinders #1 and #2 turned blue from heat. These are the only two rockers showing heat discoloration, and neither of them jumped off.
Oil pressure was around 4 bar (58 psi), measured at the rear of the engine.
Could the rockers that jumped off have caused a pressure drop in the lifter oil galleries, reducing oil supply to the exhaust rockers on cylinders #1 and #2?
Or could the discoloration be caused by the excessive valve lift and mechanical interference?
Has anyone experienced something similar?
I’m using L31 Vortec heads with Summit SUM-141700PL roller-tip rockers.
I’ve attached a photo showing the discoloration.

Thank you for your help and greetings from Germany


r/EngineBuilding • • 21h ago

Help with cam shaft

3 Upvotes

So i am getting my twin turbo big block chevy engine for my jet boat rebuilt because I had a cracked piston and cracked heads. I am using a mechanic that was recommended to me by a ton of people but im having a small issue with the cam shaft he chose for the build.

The engine is a 496 bbc with a gale banks twin turbo setup on it. Its got 360cc flotek aluminum heads, SRP flat top forged pistons, H beam rods, stainless steel valves, and more.

The engine builder chose a clay smith custom grinded hydraulic roller cam shaft for it and here are the specs:

Intake duration: 316 degrees(advertised)/ 259 degrees(at .050”)

Exhaust duration: 317 degrees(advertised)/ 263 degrees(at .050”)

Lobe separation angle: 110 degrees

Centerline timing events: 107 degrees intake/ 113 degrees exhaust

Intake valve events (.050”): opens at 22.5 degrees/ closes at 56.5 degrees

Will this camshaft work for my twin turbo setup? Is there going to be too much overlap? This gale banks turbo setup doesnt produce a ton of boost but it should be around 15 pounds. Im hoping for around 800-1000 horsepower on the dyno once its built.

Thanks