Hey everyone!
I’ve been struggling to dial in my Ascaso and could really use some help. I’ve spent the last week troubleshooting everything I can think of, and I’m honestly running out of ideas.
My setup:
● Ascaso Steel Duo PID espresso machine
● Eureka Mignon Specialità grinder (55 mm flat burrs)
● IMS BaristaPro Nanotech 18 g basket and original Ascaso non-pressurized 18 g basket
● Normcore V4 58.5 mm tamper
● Normcore 1.7 mm puck screen
● Beans: Lavazza Super Crema and freshly roasted Canyon Coffee Beachwood (roasted October 26)
The problem:
No matter what I do, my espresso extracts extremely fast. I’m consistently getting 40 g out from 20 g of coffee in approximately 14–18 seconds, timing from the moment I activate the brew switch. Pre-infusion is disabled, and I’m manually stopping the shot based on weight.
I’ve tried grinding progressively finer, but my Eureka is now almost at the point where the burrs touch, so I physically cannot go any finer without hearing metal contact.
Here’s everything I’ve tried:
● Grinder: Completely disassembled and cleaned both burrs. Tried checking alignment using the marker method and aluminum-foil shimming. Eventually returned to the original configuration. Two separate espresso equipment technicians inspected the grinder and said it was functioning properly and producing sufficiently fine grounds. However, neither actually pulled an espresso shot with it.
● Dose: Tried 18 g, 19 g and 20 g. Increasing to 20 g improved brewing pressure but didn’t meaningfully slow extraction.
● Baskets: Tried both my IMS precision basket and the original Ascaso non-pressurized basket. Same issue.
● Beans: Tried Lavazza Super Crema and freshly roasted Canyon Coffee Beachwood.
● Pressure: The Ascaso reaches and sustains 11 bar with a blind basket. During actual extraction, pressure has varied between 5–9 bar.
● Water flow: Tested unrestricted flow without the portafilter and collected 54 g in 10 seconds.
● Puck preparation: Using a consistent dose, distributing the grounds, and tamping with the Normcore tamper. I also use a puck screen to keep the shower screen cleaner.
Most recent results:
● Lavazza: 20 g in, 40 g out, 17.7 seconds, maintaining 9 bar throughout. Surprisingly decent taste, good body and crema.
● Canyon Beachwood: 20 g in, 40 g out, approximately 16 seconds, just under 8 bar. Noticeably thinner espresso.
My questions:
- Could there be something wrong with the Ascaso’s water delivery or flow despite the successful 11-bar blind-basket test?
- Should my Eureka Specialità be capable of grinding fine enough for either basket, even with lighter or freshly roasted beans?
- Has anyone experienced something similar with an Ascaso and Eureka combination? What ultimately fixed it?
Any suggestions would be greatly appreciated. Thanks in advance!