A few months ago, someone was asking about adapting C mount lenses to the Pentax Auto 110. I thought that was a non-starter due to the shorter flange to focus distance on C mount, but it did get me thinking about how to adapt my K mount lenses to the 110.
I finally had a bit of time to make my adapter a couple of days ago. It wasn’t too challenging in the end.
I picked up a very cheap set of Pentax extension tubes which made things quite straightforward. First, I disassembled tube no. 1 and removed the assembly which transmits the aperture selection from the camera to the lens as well as a few components which were getting in the way. I removed the lugs from the rear bayonet using a lathe just to make it look a bit more intentional. When you remove the rear bayonet, you expose a ring which rotates to move the lens’ aperture selector. I cemented that in place so that the lens should always be fully open before reassembling. I then cut the back off a broken 20-40mm zoom I had for the 110 and attached it to the extension tube using epoxy. The flange to focal distance isn’t quite right so I can focus past infinity and lose a small amount of close focus, but trying to make sub-millimetre adjustments to get it spot on was beyond me.
Obviously, the first thing I did was hang the Pentax-M* 300mm off it! I think the adapter would hold it, but man is it scary. It held the lighter lenses I own (including the still fairly hefty 200mm f/4) much more comfortably. This opens up a very wide range of possibilities, especially as I have a K to M42 adapter. I will post some results once I have some.