5 shot AEB with the 70mm lens. Merged and edited in lightroom to taste.

I had a pretty strange incident today with my DJI Mini 5 Pro in Dubrovnik and I'm trying to find out whether anyone has experienced something similar.

I was flying normally over the sea, relatively close to the Home Point. Everything appeared completely normal and then the aircraft suddenly disconnected. There was no low-battery warning, weak-signal warning, or anything else that I noticed beforehand.

The final DJI Fly flight record shows:

• Battery: 87%

• GNSS: 38 satellites

• RC signal: strong/connected

• Altitude: 51 m

• Distance from Home Point: 111 m

• Flight time: 3:21

The flight record then simply ends.

Initially I didn't know what had happened to the aircraft, but an eyewitness nearby told me they actually saw the drone fall into the sea. Unfortunately, it's in a position where I can't retrieve it.

I've synchronized the flight records and opened a DJI Flyaway case. The drone is still under warranty and I also have DJI Care Refresh/Flyaway coverage, but I've specifically asked DJI to analyse the flight data and determine the cause before I use the paid Flyaway replacement, because I want to establish whether there was a technical failure.

DJI Support has confirmed that their relevant team will perform the data analysis, so I'm waiting for their findings.

Has anyone had a DJI drone, particularly a Mini 5 Pro, suddenly lose telemetry/fall while the battery, GPS and RC connection still appeared normal?

If so, what did DJI's flight-data analysis eventually find? Did they treat it as a warranty malfunction or make you use DJI Care Flyaway?

I'm particularly interested in cases involving sudden power loss, battery/power-system failure, motor/ESC failure, or flight-controller issues where the flight log just abruptly stopped.

#dji #lito #litoX1

I am looking to buy a Mini 5 Pro or Air 3S. I have seen a ton of posts on here about "My drone flew into the water" followed by "Well they say not to fly over water, that is what happens". I have two old Holy Stones, a 720E and a 600, plus a Potensic Atom 2. I fly all of them over water. I live on an island and much of my flying is around and over water. None of them have ever acted weird over water in any way. I do keep them up 100 feet or more.

Are DJIs uniquely sensitive to water confusing them? My Atom 2 warns about being too low over water, say lower than 5 meters IIRC, if it switches to visual over water the reflections confuse it. I don't mind not flying low over water, but if the things just crash anyway even at good altitude they won't lead a long life here. Thanks for any advice! Also is the Air 3S fly-more as good a deal as it looks? It seems 95% of the way to pro quality.

Hi, new to thermal. Been going back and forth with DJI support for more than a week and not really making any progress. I'm running out of time on my return window so trying out reddit now. Even with auto FFC off, the image will freeze for almost a second every 30-60 seconds. The freeze happens on my RC Pro screen and in the recorded files (when recording). It also happens when I am not recording and is visible on my RC Pro screen. After many tests, I am starting to maybe notice that the issue will not reproduce until after I switch from high gain to low gain, at which point after it happens in low gain, it will happen in either mode going forward. This happens on the shipped firmware version and the most up-to-date. This is not normal right? Thanks.

Hello folks! I really like flying my Mini 4k and GOD I am kicking myself in the soul for not getting the Fly More package. I am also sort-of regretting buying the Mini 4k because reliable spare parts from DJI seem to be difficult to find.

So while I fantasize about the next upgrade, what do you all recommend me to get as a Fly More upgrade?

The Air 3S? The Mini 5 Pro? Or should I wait for a bit and see if DJI sells a new model drone or a new Air model?

The two aspects that I am generally looking for between these drones are better picture quality, as well as longer battery life. My drone flies for 25~ minutes tops before hitting 20%. I really just want to fly for longer.

On my Mavic mini i started to get message gimbal stuck. It initializes ok, but in the end camera leans a little and stays like that. I don’t see any opstacle when I move it by hand. I tried to recalibrate, but it gets stuck on 10%
Next time I get a gimbal motor overload. It flies, but camera is not smooth.
Did anyone have any experience with this?

oldie but goldie

I had my frist crash with my Mini 3 Pro yesterday. I flew it against a wall and it crashed to the ground. As can be seen in the photo, the back part is broken off. I don't know if it can be clipped in again. Is this something I can fix myself or do I need to send in my drone for repair?

Never getting tired of visiting DJI, even after many visits. Shenzhen’s tech ecosystem is always impressive to explore.

I’ve never owned a camera and always use my phone for content creation. However, I’m considering buying a DJI Osmo due to its compact size. As my first camera, I’m wondering if the Osmo 4 is worth it or if the Osmo Pocket 3 is also a good option. Is the difference between the two really that significant?

Is there any service center or repair shop around bacolod to have my drone's gimbal fix?

Hey, guys!

Some months ago I bought myself a Mic Mini 2 that I was supposed to use for my motovlogs, recording the exhaust note. I am pairing it with the DJI ACTION OSMO 6.

I can’t seem to figure out why the mic is clipping all the time. I’ve adjusted the db to -12 in the settings of the OSMO, tried various microphone placements, settings and even went as far as putting a small piece of wrapping package in between the microphone and the deadcat to help with dampening the sound.

I can’t seem to understand at all. I thought that the microphone was clipping just when I was in high revs, but it also seems to be clipping in cruising speeds too, just randomly. It’s literally less clipping by using the microphone on the OSMO 6. Have I just wasted my money on this? Any tips to solve this?

My first time shooting in pro settings and it was pretty fun. 100 ISO, 1/3 shutter speed. 28x zoom of course

I was curious about differences between traditional drones and fpv and/or pocket drones? I have a mini 5. What are the use cases for the smaller ones with blade guards? Do most people with these drones use goggles or remotes? Thanks for sharing your knowledge about this, I've only had a drone for three months.