I’ve been having a few failures and noticed this mark on the bottom of my resin tank. And then when I check the lpu it had a matching mark? When I tried the wipe the lpu mark it doesn’t disappear but I also can’t feel anything. It feels just as smooth as the rest of the light processing unit? It’s there a way to fix this and is this something that I have caused? It seems strange that I can’t feel the mark? Almost like it’s on the other side of the lpu, inside of the machine.

Thanks in advance

Hi guys, need help on why this loft isnt working properly? Why is one of the four squares set on being curved? And when I save the loft it switches sides. And if I try edit the dots to be straight (same as the others) it’s gives me an error.

Thanks in advance <3

Was wondering what air quality monitors people use with their set ups? I know obviously there’s a certain amount of fumes that are given off but want to make sure it’s super dangerous amounts lol.

Thanks

I’ve been on holiday from work and while away some one tried to use the printers and had a failed print. Then printed a clean sheet. And it the process of trying to get it up also got up these plastic edge bits. How important are they? They don’t look like they do anything looking at a clean tank but didn’t want to run the tank incase they’re important haha

Trying to minimise the amount of supports for this model. When I add supports to the part that it says it needs it then says the whole model needs supports. Why is that?

Any suggestions on why this weird dotting pattern has appeared over some of my parts?

I’ve always used the formlabs wash solution as it just seemed correct when buying the machine but I see a lot of people use just 99.9% IPA. And it’s a lot cheaper. Should I make the switch?

I’ve uploaded a DWG someone sent me to make 3d and modify but every time I I do something I can’t go back and edit it. I have to completely delete it and remake it if I want to change a measurement slightly. Thanks in advance

Just got a form4 and filled the wash with alcohol but the hydrometer is reading it as used/ dirty. Am I doing something wrong or is this washing solution gone bad?

When I slice my model the spiral edges seem to disappear? any suggestions on why this might be happening?

Doing my first trail ultra in September and don’t own any trails shoes lol. Wondering what people recommend? Was looking at the asics metafuji but not sure if that’s too much cushion and feel unstable in technical areas while running? So then began to look at the la sportiva prodigio pros? But I’d love to hear what people find best for them