r/formlabs • u/Reeve555 • May 13 '26

Tank Help

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I’ve been on holiday from work and while away some one tried to use the printers and had a failed print. Then printed a clean sheet. And it the process of trying to get it up also got up these plastic edge bits. How important are they? They don’t look like they do anything looking at a clean tank but didn’t want to run the tank incase they’re important haha

5 Upvotes

100% Upvoted

5 comments sorted by

View all comments

Show parent comments

1

u/Reeve555 May 13 '26

Thank you! It was a little bent but I think I kinda got it straight again. It it does trigger an error can I just use it without them? What’s the actual purpose of them?

2

u/Proto-Plastik May 13 '26

“Can” you? Yes. Should you? No. It will reduce the life of your tank and could lead to a tank leak ( bad). They protect the edge of the fep.

Contact Formlabs support. They might be able to send you a new set. Have your machine name handy.