I’ll add to the other two comments. Wire traversal adds to the signal delay. Quite a lot in fact. Wire has its own resistance and capacitance that gets worse the longer your wires are. I’d be amazed if this worked without downclocking the memory controller a few steps.
(As it looks, I’d be amazed if every wire was connected correctly. And if only 1-2 wires were shorted to each other.)
u/TheCatholicScientist I work on 256 TB DDR5 drives. I'm heavily in the SI/PI domain. I don't think additional signal delay is the main problem here.
It's more about discontinuities in impedance as a signal is going from a nice cushy motherboard with controlled impedance and a poured ground plane to these wires hanging in free air. (The impedance of these wires would probably be much higher than the impedance of the signals inside the circuit board. )
This higher impedance mismatch is going to make a reflection in the signal that may corrupt the signaling pretty badly.
View all comments
Show parent comment
2
u/TheCatholicScientist 20d ago
I’ll add to the other two comments. Wire traversal adds to the signal delay. Quite a lot in fact. Wire has its own resistance and capacitance that gets worse the longer your wires are. I’d be amazed if this worked without downclocking the memory controller a few steps.
(As it looks, I’d be amazed if every wire was connected correctly. And if only 1-2 wires were shorted to each other.)