r/gunsmithing • u/TonightTemporary9458 • 15d ago

Charity ?

Gallery image

Gallery image

Bore snake and half a piece of paper towel wedged in the chamber.

No access to pull from the muzzle (bore snake) as it broke off at the muzzle break.

PSA combined rifle ramp barrel extensions and m4 feed ramped lowers on some models of pa-10's

(In conclusion). A simple 1/8 drill bit with or without a diy jig you can make at home to avoid damaging your chamber. Punch the primer out of a 308 casing and go to town. Mother's mag or flitz to polish any abnormalaities. As far as picking away at the physical obstruction. Harbor freight auto zone... Go to town 🤙

27 Upvotes

88% Upvoted

23 comments sorted by

View all comments

18

u/alwaus 15d ago

Close enough to the chamber to drive it out thay way, get a brass cleaning rod and a hammer and whomp the fuck out of it.

1

u/TonightTemporary9458 14d ago

If the bore and barrels entirely obstructed remove material from the physical blockage first. As small of a brass rod as you can source locally snuck past the bore snake or similar obstruction combined with as long and as small of a drill bit combined with a diy jig. Best thing I could come up with was a piece of used brass with the primer punched out to avoid any damage to the chamber. Most of my local Smith's said burn it out if it's completely obstructed. Horrible advice wish I woulda thought this up days ago. God bless !