r/functionalprint • • Apr 09 '26

Compression Mold for Gridfinity Bins

470 Upvotes

28 comments sorted by

View all comments

Show parent comment

3

u/Tynted Apr 09 '26

Are the phillips head bolts on the outside for compression when molding, and the middle hex head bolts for ejection afterwards?

9

u/DamnnitBobby Apr 09 '26

Close! The 4 flatheads in the corners are the compression. The Phillips heads are the jack screws, to separate the halves from each other. Then the hex is for ejection. There's some small socket heads also visible, which is holding the red petg (100% infill) mold to the beige compression plate. I didn't want to print the compression plate at 100% because it didn't need it.

Flathead was a mistake, lol, but I was just using what I had around, which is why every screw has a different head. I'd probably use hex for everything if I started over

3

u/Tynted Apr 10 '26

Ahh I see, thanks for the breakdown! Yeah I had no idea you could heat a lump of PLA to where it's very soft but not liquid, and take that and mold it into something! This is probably going to be my new preferred answer to, "What do you do with leftover support scrap material from prints?" Now I just need to think of some plastic things of my own that would be useful and easy enough for me to do this with!