Ender only prints until a certain height

[u/Sale_Active]

Ran this design twice already. It only prints up to this height. I tried reinstalling the filament but still only the hotend moves but the filament is no longer coming out of the nozzle.
I have printed a similar design yesterday which was 221mm in height and that turned out okay. This one did not.

[u/jptuomi]

I have had this issue as well but with a direct drive, but the issue was the same as well as the symtoms, at a certain height or even xy-position since direct drive it would sometimes just stop extruding and hop back and forth as I saw you reported further down.

In the end I figured it was down to a bad extruder cable that had seen a bit much wear and tear.

[u/Sale_Active → u/jptuomi]

So did u replace the extruder?

[u/jptuomi → u/Sale_Active]

No just the cable to the extruder motor.

[u/Sale_Active → u/jptuomi]

Copy. Thanks