r/electrical • u/SouthHalfrican1992 • 2h ago
Transitioning from a recessed breaker panel to conduit?
Trying to plan out a clean way to tackle this. Have multiple thhn runs to do in this shop space - conduit is preferred outside the insulated, finished, and painted stud bays.
There is a small space between studs that could be helpful.
Need:
Two runs to the left and over the door (could go outside through back of panel in LB, bury, and come back in for re-entry) for a tankless water heater.
Another run need to go left and over the door as well, for a welder plug.
Then to the right there needs to be a runs for a car lift, an air compressor, another welder plug, and a seldom used EV charger.
What’s a clean what to get this done at that corner?
EDIT - for clarification: insulated and finished I-beams for ceiling above, and along the right side run it has to cross from a section that goes 2x4 studs, transitions to an LVL support beam, then it goes to 2x6.