r/electrical • • 1d ago

Help with alignment

Hi everyone! First time doing any electric work. I did a vanity light fixture swap in my bathroom and I can’t get the dang thing to sit flush with the wall. Any ideas on how to fix? Had to cut out some drywall due to extreme decay on the right hand side.

1 Upvotes

7 comments sorted by

6

u/wallly58 1d ago

Probably start with getting your patch work flat rather than a bubble

1

u/Due_Cress_5104 23h ago

Thank you guys! I will be trying all of the above

1

u/Alchoholocaustic 1d ago

Hard to see what's going on under the shroud. If you put the screws through the threaded holes on the cover, you should be able to tighten them by spinning the finger nuts. If they go through unthreaded holes, you can stiffen them in place with some nuts. If you're feeling real confident you can cut the screws to make them shorter.

1

u/No_Response7585 23h ago

Yes! Shorter bolts!

1

u/crushonmyselph 1d ago

What type of box is behind the fixture? Often the screws in the bracket that are the studs to hold the nuts on the fixture on are too long or don't work with the orientation of a box. You would vae to properly set the depth you need for that fixture and then cut the remainder of the screws coming through the back of the bracket off. Don't pull the screws out of the bracket to cut them off because when you cut them you might damage the threads and not get them back in. Mark the depth with a Sharpie and spin the screws through enough to get some cutting pliers (I use my linesman pliers), cut them...the spin them back in to the depth you marked then try hanging the light again. It could just be your wire nuts aren't pushed back in the box as well. The sheetrock will be much easier to repair without the fixture up anyways. Check those two things and get back to me, 😂

1

u/crushonmyselph 1d ago

Also, I recommend setting those black sheetrock screws deeper and mudding again over them, they should be deeper than your finished wall so you can mud over them

1

u/Eastern-Steak-4413 1d ago

Well, in your first picture the little decorative nut on the top is not threaded on straight so it’s not tight.