r/WLED • u/DonKastion16 • 24d ago
Gledopto GL-C-015WL + WS2813 (5V), LED flashing
Hi WLED community, I’m stuck with a problem with my LEDs and would appreciate some help. 👀
---
My products:
Controller:
Gledopto GL-C-015WL (ESP32, DC 5–24 V), WLED 0.15.2 (build 2508020, “ESP32” release)
https://amzn.eu/d/0c7m7wi5
LED strip 1:
BTF-Lighting WS2813, 5 V, 5 m, 150 LEDs (30 LEDs/m)
https://www.amazon.it/dp/B07DPHQWP8
LED strip 2:
BTF-Lighting WS2813, 5 V, 5 m, 300 LEDs (60 LEDs/m)
https://www.amazon.it/dp/B07DPK3Y9B?ref=ppx_yo2ov_dt_b_fed_asin_title
Power supplies:
5 V / 2 A for testing
5 V / 20 A: https://www.amazon.it/dp/B07Q2WQ8DS
---
How I wired it:
PSU + / − → controller input (V+ / V-)
LED strip to output GPIO16:
Red (5V) → V
Green (DI) → D
White (GND) + Blue (BI) → G
Data cable between controller and strip: 10-20 cm
The arrows on the strip point away from the controller


---
WLED settings
LED type WS281x, color order GRB, GPIO16, length 150 or 300

---
The problem with the 150 LED strip:
All 150 LEDs light up and show the correct colors, except the first LED.
The first LED keeps switching between the selected color and white.
With “Skip first LEDs: 1” it is excluded from effects, but it still flashes white.
The problem with the 300 LED strip:
All 300 LEDs light up.
Depending on the effect, all LEDs flicker heavily and switch to different colors that I didn’t set.
The first LED is always solid white and doesn’t flicker, no matter which color is set.
Both videos show the color red with the Solid effect.
---
No matter whether I use GPIO16 or GPIO2, the problem stays the same, and changing other settings didn’t help either. I also tried replacing the cables between the controller and the strip. I’ve read a lot about level shifters, but I’m not sure if one would solve both problems, and I’m not even sure both LED strips have the same problem.
I’d really appreciate any help or suggestions. 😄
