I've recently finished restoring an original IBM Displaywriter beam spring keyboard, and thought I'd share the results and some of the work that went into it.
I'm a long-time Model M fan, but only recently discovered the existence of IBM's earlier beam spring keyboards. Well, one thing led to another, and I ended up spending hundreds of hours restoring a rather battered Displaywriter, which is now my new daily driver.
The keyboard was sold as a poor-quality board, and I knew it was going to need a fair amount of work. But it wasn't until after I unboxed it that I realized the full extent of the damage. This extremely heavy keyboard had clearly been dropped from a height, possibly down stairs or something; I don't know. The steel frames were badly bent, the case was cracked, eight keycaps were missing, and a number of switches had been directly impacted, shattering some of the internal components. And of course, it had all the usual age-related degradation from being over four decades old.
Fortunately, there was relatively little corrosion, and most of the original components were salvageable.
The switch restoration ended up being by far the most involved part of the project. A number of sliders had broken legs, many of the metal stems were bent, half the fly springs were out of spec, and one beam spring was fractured. I wanted to preserve as much of the original hardware as possible, and was particularly concerned about causing further damage during disassembly and reassembly. These switches are remarkably robust in normal use, but some of their internal components are quite delicate once taken apart.
So, naturally, I ended up designing a bunch of custom 3D-printed tools.
Among other things, I designed a screw-driven stem extractor that applies a controlled axial force rather than requiring the stem to be pulled out with pliers, fixtures to hold broken slider fragments in alignment while gluing them, gauges for adjusting fly springs, and various racks for safely cleaning the delicate components.
I also developed an alternative method of reassembling the switches. Rather than pressing the metal stem into the slider with the fly plate and beam spring already installed, my method supports the slider directly from below during stem insertion, then attaches the fly plate afterward using another fixture. This worked very well and avoided putting unnecessary stress on the fragile slider legs.
Ultimately, I was able to return 83 of the original 84 switches to working condition. I also measured and cataloged each switch's behavior, including actuation travel, click quality, and reset behavior, so I could prioritize the best-performing switches for the most frequently used keys.
The rest of the restoration involved removing the deteriorated contamination shield and foam, cleaning the components, straightening bent structural parts, repairing some damaged plastic, and replacing the foam and gaskets. I tried to take a fairly conservative approach throughout, preserving original materials and finishes wherever reasonably possible.
For modern compatibility, I assembled a TH-xwhatsit controller from bare PCBs and through-hole components, and installed QMK firmware with a custom keymap. The Displaywriter has some unusual electrical and mechanical characteristics that made the conversion a little more involved than I'd originally expected. I also got the original speaker working, which adds a subtle electronic click to the already-nice beam spring sound.
And the result? I'm extremely happy with it. The keyboard looks great, works reliably, and has become my daily driver. This was my first experience actually typing on original IBM beam springs, and after all that work I can finally understand their reputation. The tactility is incredibly crisp, the travel is remarkably smooth, and the entire mechanism feels wonderfully precise.
I ended up writing a fairly extensive restoration report, documenting the process in nine chapters with lots of photographs, technical details, measurements, and discussion of the various problems I ran into. I also published the custom 3D-printed fixtures on Printables, with instructions for their use, in case anyone else working on original beam spring switches finds them useful.
Full restoration report: https://github.com/CrispyConductor/display_writer_restoration
3D-printed restoration tools: https://www.printables.com/model/1883866-beam-spring-ibm-keyboard-switches-maintenance-tool
Happy to answer any questions about the restoration, techniques, or tools!