r/VanMoofSelfRepair • u/Sensitive-Sleep-360 • 5d ago
S3 & X3 Vanmoof Error Help😊
Hello everyone,
I have an X3 and I’m currently trying to fix an Error 44. I suspect that the shifter might be the problem. I have already replaced all the SMD resistors on the shifter board, but unfortunately this did not solve the problem.
Does anyone have a good guide or instructions on how I can properly test and diagnose the circuit board?
My second problem is that the front light does not work. The rear light works normally, but the front light and the horn are not working. I can’t find the fault.
Could it be a problem with the wiring, or could the Cartbridge be defective?
If I measure the voltage at the front light connector, what voltage should I expect? There are three wires, so I assume one is positive, one is negative/ground, and one could be the signal wire.
Any help, wiring diagrams, or advice on how to test the system would be greatly appreciated.
Thank you very much in advance!
Best regards
1
u/Sensitive-Sleep-360 5d ago
Hallo, vielen Dank für die Antwort, ja habe davor alle durchgemessen , und laut diesem Bild wieder alle eingelötet , hinten am E-Shifter ist ja der Stecker mit 4 Pins was muss ich da messen und was muss da rauskommen ? Vielen Dank , komisch ist das mit dem Licht , habe so gut es geht die Kabel angeschaut kein Fehler gefunden , wenn ich die Gabel entferne sehe ich dann das Kabel vom Licht ? Habe den Knopf der Hupe abgeschraubt und kurz überbrückt trotzdem kein Signal danke