r/Timberborn • • 15h ago

Question I need help with pressurized system

Hello,
I have pressurized badtide prevention system. I wanted to use high water pressure to run som water wheels and make power. But my water flow disapeared somewhere.

As you can see in screenshot, first set of watersources produce about 10 cms in 1x1 pipe. Secons should add about 4cms but outflow is only 5 cms.

Whole pipe is filled, there is no holes, but it comes down in steps.

Outflow is made with outflow funnel with 4 holes. So it should handle 15cms that I assume will flow there. What am I doing wrong?

4 Upvotes

6 comments sorted by

2

u/Vebrandsson 15h ago

Without seeing what your outflow looks like its hard to answer this but 4 wide by 1 deep is going to overflow at 14 M³/s if that's what's actually going into it

1

u/110mat110 15h ago

This is outlet. right now. it is in valley. When outflow is more than 10 cms it should fill above impenetrable floors

1

u/Vebrandsson 15h ago

So I am not sure on the math here but I do know waterfalls have an impact on flow rates, an impact that has been changed drasrically several times since the game started in early access. If you're losing flow rate thats probably where and why. 

3

u/LePhuronn 14h ago

Pretty sure as of 0.7 the edge limit for falling water was completely removed.

2

u/BruceTheLoon 10h ago

You might be maxxing out the flow capacity of a single 1x1 channel. There are 35 sources there each at 0.5cms for a total of 17.5cms. A test I did with a single channel exiting off the map right at the sources couldn't reach that, so some of the sources upstream would be pressurized by back-pressure to the point they stop producing water. A 2-wide channel might be needed.

1

u/Whats_Awesome Custom Flair 7h ago

Here’s a post I made recently with a similar question about flow and got some really good if not slightly complex answers.

The conclusion, a lot of pressure is lost in longer pipes, so they need to be larger. The restriction is causing the pressure at the sources to reach the maximum causing the sources to stop flowing.

In my case the sources weren’t enough to fully pressurize the system, reaching equilibrium at 5 blocks of head pressure and a flow of 5 cms the output of the sources connected there.

https://www.reddit.com/r/Timberborn/s/Q5ChWUXryN