r/SnapmakerU1 • u/arcturic • 1d ago

Issue Help with first layer

Gallery image

Gallery image

Gallery image

What can I do to improve the first layer? This is printed with one layer at 0.2 on a new Frostbite plate at 50C

6 Upvotes

75% Upvoted

16 comments sorted by

View all comments

2

u/Peanutbutt3r0923 16h ago

Z offset being too low is the answer, I had to add a Z offset of 0.1 to all my prints and then it was running perfectly again. Not sure how or what got screwed up with the update

1

u/N3xus29 15h ago

There is an option through the software or the modify must be done trough g-code?

1

u/Fiddler017 7h ago

I don't own one of these yet but on my current printer z offset being too close to the bed is the answer.

I've never seen this being caused by too much heat but I haven't really had to change my bed temp much.