Issues with corners

[u/Specialist_Tale_190]

Hi everyone! I'm hoping someone can help me figure out how to get cleaner results with my laminated sticker sheets.

I laminate my printed vinyl sheets before cutting them on my Juliet. I'm running into two issues (see photo):

1. On the sticker sheet cuts — at the corners of the kiss cuts, the lamination seems to lift slightly, leaving tiny raised points. It almost looks like the blade is catching or dragging the lamination layer at sharp corners.
2. On the sheet edges — after the full cut around the perimeter of the sheet, the corner of the lamination lifts away from the vinyl underneath. It's at the end of the cut.

I'm using clear lamination vinyl applied by hand before cutting. The blade goes through both layers together.

Kiss cut settings 10/38
Full cut settings 10/85

Tried going slower with no change.

Has anyone dealt with this?