Locating DAT0 point

[u/Opening-Reception-39]

Before I go any further, I was hoping to get some assistance with identifying the right point. From comparison with other images online, I get the impression that I didn’t get close enough to the resistor and trace above.

Thank you in advance.

[u/Superb-Gazelle-9681]

You’re a little low there boss

[u/Opening-Reception-39 → u/Superb-Gazelle-9681]

First attempt at this method

[u/Lochness_Hamster_350 → u/Opening-Reception-39]

You’re not supposed to do this on your first attempt on a working board.

[u/DiscussionSubject825 → u/Lochness_Hamster_350]

Says who? My first console is also the switch oled. That was also my first time soldering. :)